User manual PARKSIDE KH 3177 ANGLE GRINDER

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. The following pictogrammes / symbols are used in these operating instructions: Read the operating instructions!Protection category II power tool; double insulated Wear hearing protection, dust protection mask, protective glasses and protective gloves. Keep children and other unauthorised personnel at a safe distance when using electrical tools. [. . . ] This precaution is intended to prevent you from unintentionally starting the device. When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. Always work with the mains lead leading away from the rear of the device. J Grinding discs must be carefully kept and handled in accordance with the manufacturer's instructions. J Make sure that abrasive consumables and tools are attached in accordance with the manufacturer's instructions and advice. J Ensure that any spacers supplied or required for the use of certain abrasive consumables and tools are properly installed. J Before you use the device make sure that the abrasive consumable or tool is correctly attached and firmly fastened in place. Allow the tool to run under no-load conditions for 30 seconds in a safe position. Stop the device immediately if a significant amount of vibration occurs or if any defects are found. in this event check over the machine to find the cause of the problem. J Never use the electrical power tool without its disc guard cover, if it was supplied with one. J When using abrasive consumables and tools with a threaded insert make sure that the threaded hole is long enough for the spindle length. J Do not work in areas where there may be concealed electricity cables or gas or water pipes. Penetration of a water pipe can lead to property damage or to electric shock. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / noxious dusts represents a risk to the health of the person operating the device and to anyone near the working area. Wear hearing protection, protective glasses, a dust protection mask and protective gloves. [. . . ] After replacing a disc let the device run under no-load conditions for 30 seconds as a safety check. Pay attention to see that the arrow showing the direction of rotation on the roughing / grinding or cutting discs (including diamond cutting discs) corresponds with the direction of rotation of the device (see arrow on the head of the device). For safety reasons this device must always be used with the auxiliary handle 6 in place. J Pull the mains plug out of the mains socket before you carry out any task on the device. [. . . ]