User manual PARKSIDE KH 3162 HAMMER DRILL

[. . . ] The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in En 60745 and can be used to compare devices. Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. [. . . ] Loose clothing, jewellery or long hair can become trapped in moving parts. G) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. Careful handling and use of electrical power tools a) Do not overload the device. Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. An electrical power tool that can no longer be switched on and off is dangerous and must be repaired. C) Pull the mains plug from the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device. D) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not famil- The effect of noise can cause hearing loss. If the inserted tool jams, switch off the electrical power tool immediately. For your safety, the hammer drill PEBH 1010 has been fitted with an overload clutch. this ensures that the drive is automatically disengaged if the drill bit jams. Nevertheless, you must always keep proper General safety advice for electrical power tools / Preparing for use Footing and balance, hold the hammer drill firmly with both hands and use the auxiliary handle 9 . Working with harmful / noxious dusts represents a risk to the health of the person operating the device and to anyone near the working area. [. . . ] Switching on permanent operation: j Press the On / OFF switch 4 and lock it in the on position by means of the locking button 5 . Switching off permanent operation: j Press the On / OFF switch 4 and release it again. With the wheel on the speed pre-selector 6 you can pre-select the operating speed to your individual requirements. If a low speed has been pre-selected, the On / OFF switch 4 is automatically restricted in the extent to which it can be pulled back (due to the reduced speed of rotation). [. . . ]