User manual PARKSIDE KH 3160 CIRCULAR SAW BENCH

[. . . ] If you pass the device on to anyone else, please ensure that you also pass on all the documentation. The table saw is intended for sawing edged workpieces of wood and chipboard. Any other use or K) 2 Blade guard 2a Vacuum dust extraction connection 3 Riving knife 4 Saw blade 5 Saw table L) Mitre guide handle with clamping screw (see Fig. L) 9 Centimetre-scale 10 Counter wrench (including 10 mm and 13 mm open-end spanner) 11 Combi-tool (6 mm Allen key / Phillips screwdriver) 12 Push stick 13 Safety lock thumb knob 14 Blade height adjustment wheel 14a Blade height adjustment wheel handle 15 Blade angle scale 16 Safety ON/OFF switch (including EMERGENCY-OFF) 17 Reset-switch 18 Blade angle adjustment thumb knob 1 Table saw PTKS 1800 SE 1 Blade guard 1 Guide fence 1 Mitre guide 1 Counter key 1 Combi-tool 1 Push stick 2 Extraction adapters for 2 and 20 Noise and vibration data: Referring to A-weighted sound level. [. . . ] Pull the mains plug out of the socket if the mains lead becomes damaged during use. If you use the electrical power tool outdoors, always connect it through a residual current device (RCD). Connect the electrical power tool to a properly earthed power circuit. Sockets and extension leads must have properly functioning earth contacts. Serious injuries could result if the table tips over or you inadvertently come into contact with the saw blade. Keep your hands clear of the saw blade and away from the area around the saw. Never reach behind the sawblade to hold the workpiece, remove sawdust or for any other reason. Otherwise there is the danger of kickback if the saw blade gets caught in the workpiece. Use the electrical power tool only if the working area is clear of all setting tools, sawdust etc. Any small pieces of wood Operating the machine safely: J Use the push stick to guide the workpiece safely past the saw blade. J Do not carry out any rebating or grooving unless a suitable guard, such as a tunnel guard, is attached to the saw table. J The circular saw must not be used for slotting (a groove ending in the workpiece). J Only use saw blades that have a highest permissible speed not less than the maximum shaft speed (rated speed of the table saw and the workpiece being sawn). J Transport the machine by the provided handling points only; do not use the guards to handle or move the machine. J The top part of the saw blade must be covered by the saw blade guard during transport. Curved or round workpieces must be secured against slipping during sawing. J Take precautions when working with dusts which may be hazardous to health, combustible or explosive. Safety advice / Preparing the device for use Or other objects that come into contact with the rotating sawblade could strike the operator at high speed. Workpieces placed one above the other or side by side may jam the sawblade or slip with respect to one another during sawing. This will improve the accuracy of your cut and reduce the risk of the blade jamming. If the saw blade jams or you pause from your work, switch off the machine and hold the workpiece still, until the saw blade has reached a standstill. Never remove the workpiece while the saw blade is still rotating, otherwise this may result in kickback. [. . . ] 12 special spanner 11 counter key 10 and the operating instructions in the holders in or on the table saw. Before you carry out any work on the device always pull the mains plug out of the mains socket. never any kind of sharp object or petrol , solvents or cleaning agents. Have your device repaired only by qualified specialist personnel using original manufacturer parts only. [. . . ]