User manual PARKSIDE KH 3143 2-SPEED HAMMER ACTION DRILL

[. . . ] Please make sure you familiarise yourself fully with the way the tool works before you use it for the first time and that you understand how to handle electrical power tools correctly. In addition to the above, you must also observe the general safety advice contained in the accompanying booklet. If you pass the tool on to anyone else, please ensure that you also pass on all the documentation. Parts that can be replaced by the user: a) Auxiliary handle b) Depth stop If these parts become damaged or lost please contact the service centre for your country in order to replace them. [. . . ] J Do not operate the device if it is damp and do not use it in a damp environment. J If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. J o not work in areas where there may be D hidden electricity cables or gas or water pipes. To avoid the risk of injury: Wear protective glasses, hearing protection (noise can lead to hearing loss), dust protection mask and protective gloves. Please note that working on stone or metal can give rise to hazardous dusts that can adversely affect your health. J e particularly careful when screwing in longer B screws - the driver could slip off the screw head. This is much safer than holding it in your hand and it means you then have both hands free to operate the electrical power tool. J J J J J If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Before you insert the mains plug into the socket, always check that the device is switched off. When taking a break from your work, before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket. Do not use the device if you cannot concentrate or you are feeling unwell. J ou will require a suitable bit holder if you wish Y to use screwdriver bits with the drill. For reasons of safety, this device must be used only with the auxiliary handle 8 in place and properly attached. It is essential that you note the following: if the drill becomes jammed, a very large torque can be generated (, , the force that the machine will exert to rotate about its own shaft"). Before starting any tasks on the hammer drill, make sure that it is switched off and the mains plug is out of the socket. The RÖHM quick-release drill chuck allows you to exchange drills or other tools without using a special key etc. Switch on constant operation mode: j ress the On / Off switch 3 , and keep it P pressed, then press the locking button 4 . Switch off constant operation mode: j Press the On / Off switch 3 and release it. J old the rear shell of the quick-release chuck 9 H and turn the front shell until the tool (e. [. . . ] Before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket. For best results, C clean the device immediately after you have finished using it. The gear selector switch must only be moved after the drill has come to a standstill. J elect between the following speed ranges S using the gear selector switch 7 : 1 = low speed range 2 = high speed range Do not dispose of electrical tools with household rubbish! [. . . ]