User manual PARKSIDE KH 3133 BENCH DRILL

[. . . ] Any other use or modification to the device shall be considered as improper use and could give rise to considerable risk of accident. We will not accept liability for loss or damage arising from improper use. Bolt (drilling table inclination) Column Motor unit Drive wheel (motor side) Middle drive wheel Drive wheel (spindle side) V-belt Interlock switch 1 Hex Allen key 2 hexagon socket head bolts Chuck key Noise and vibration data: Referring to A-weighted sound level. sound pressure level: 72 dB (A) Sound level: 85 dB (A) Uncertainty K=3 dB. [. . . ] All parts must be correctly attached and fulfil all the requirements necessary to allow the electrical power tool to operate properly. J Damaged safety equipment and components must be properly repaired or replaced at a competent electrical equipment repair centre unless otherwise indicated in the operating instructions. J Never use an electrical power tool that cannot be switched on and off properly. J The use of inserted tools and accessories other than those recommended by the manufacturer could lead to you being injured. Have your electrical power tool repaired at an electrical equipment repair specialist. J This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. Check that the interlock switch 29 under the drive / belt cover 6 is working properly: The bench press drill must switch off automatically when the drive / belt cover 6 is opened. Failure to observe this advice may lead to the gloves becoming wound around the revolving parts. Be aware that persons operating the device or in its vicinity may be at risk of being in contact with or inhaling dusts. Machining metal can result in electrically conductive dust being deposited inside the device. Operate the device through a residual current device (RCD) with a trip current of 30 mA. Do not drill moist materials or damp surfaces, Never leave the device working unattended, Never use the device for a purpose for which it was not intended. Always work with the mains lead leading away from the rear of the device. Safety advice relating specifically to this device J J J J J CaUTIOn: Too high a pressure overloads the motor and reduces the drilling speed Always use sharp drill bits Cool the drill bit with a suitable liquid Use a special drill bit for drilling into stainless steel Check before every use that the chuck 3 , the drilling table 19 and all the threaded fasteners J First clean the corrosion-protection coated parts (column 23, the base, the vice 13 and the chuck 3 ) e. Bolt them together in the following order: Flat washers 17 a / retaining rings 17 b mounting bolts 17. J Place the drilling table 19 on the column 23, slide it fully downwards and fix it in position with the clamp bolt 16. J Fasten the vice 13 to the drilling table 19 with the vice bolts 20 / flat washers 20 a / nuts 20 b. The elongated holes allow the vice to be fastened in different positions. Insert the guard 5 into the mount and attach it in place with the 3 bolts, retaining rings and nuts in the mount. J Release the wing bolts, bring the bottom part of the guard into the desired position and then tighten the wing bolts again. Secure the motor unit 24 by tightening the two hexagon socket head bolts 31 at the side using the Allen key 30. [. . . ] Further application examples Drilling ceramic tiles / plastics: j Use a low speed. Place the workpiece between the jaws 14 and clamp it by turning the clamping bolt 21 clockwise. Note: The vice 13 can be used to clamp flat and rectangular workpieces. Always pull the mains plug out of the socket before doing any work on the device. [. . . ]