User manual PARKSIDE KH 3113 ELECTRIC SCRAPER/CARVER

[. . . ] Switching off the device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Preselecting the speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Advice on use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Page Page Page Page 8 8 8 8 8 Cleaning and disposal Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Have repairs carried out only by an electrician í Q W E R T Features and equipment · Speed setting wheel ON / OFF switch Tool attachment Tool holder Tool lock · 6 UK Safety/Before Use/First use · · or the relevant service centre. Do not operate the device if it is damp and do not use it in a damp environment. If you use the device outdoors, always connect it through a residual current device with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. Always work with the mains lead leading away from the rear of the device. Do not use the device if you cannot concentrate or you are feeling unwell. · · í Before use í To avoid danger of injury and hazards to health: · Wear protective glasses. Pieces of material may split off the workpiece and become projectiles. · Do not soak the materials or the surface you are about to work on with liquids containing solvents. The heat generated during scraping can give rise to poisonous vapours or gases that are hazardous to health. · Secure the workpiece by holding it in a clamp or vice, otherwise the workpiece cannot be securely held in place and could cause injury. · When working, always hold the device securely with both hands (see Fig. Never support yourself by placing your hands near or in front of the device or the workpiece surface. Keep children away from the mains lead and do not allow them to use the device. Children often underestimate the dangers associated with electrical equipment. Using the device safely: · If danger arises, pull the mains plug immediately out of the mains socket. · Never use the device for a purpose for which it was not intended. · Handle the device carefully and treat it with Quick-change tool holder cause injury. ½ Danger!The sharp edges of the tools could ½ The choice of tool depends on the intended task. The supplied accessories are suitable for the most common tasks (see figures C, D, E and F). Push the tool attachment into the tool holder R until it reaches the stop. [. . . ] = Note: The optimum speed depends on the material and the surface to be worked. If you find that you are not removing enough material, increase the speed by one setting. í Advice on use ½ Warning!Always pull out the mains plug from the socket: when you are no longer using the device when taking a break from your work before changing the tool attachment before cleaning the device Caution!½ Guide the switched on device slowly with the tool attachment up to the material to be worked or surface to be stripped. [. . . ]