User manual PARKSIDE KH 3107 HOT AIR GUN

[. . . ] Please read the operating instructions below and the accompanying safety advice carefully. By doing this you will be able to work in complete safety and produce better results. We hope you enjoy using your hot air gun. FEATURES OF THE PHLP 2000 ³ · On/Off switch/ Two setting switch 375° C / 550° C Nozzle » ¿ ´ Air inlet and outlet Thermal protective cover Interchangeable nozzle attachments TECHNICAL INFORMATION Voltage: Output: Airflow: Air temperature: Electrical protection: Weight: 230 V ~ 50 Hz I = 1000 W II = 2000 W I = 300 l/min II = 500 l/min I = 375° C II = 550° C II 0. 7 kg SPECIFIC SAFETY ADVICE To be read in conjunction with the advice in the accompanying booklet on safety advice. Have any damaged parts repaired or replaced at a specialist repair centre. [. . . ] Keep children well away from the equipment. 4 NOZZLE ATTACHMENTS Reflector nozzle Spatula nozzle Flat nozzle Cone Nozzle MAINTENANCE OF YOUR HOT AIR GUN 1. To work safely and in accordance with the regulations see that the air vents are always kept clean. A damaged mains lead and any other damaged parts must be replaced with a special cable or replacement parts which can be obtained directly from the manufacturer or a specialist service centre. Never use petrol, solvents or cleaners that might attack the plastic. 5 ADVICE ON WORKING METHODS, TIPS AND TRICKS Caution!Working with plastics, paints, varnishes and similar materials can give rise to flammable and poisonous gases. Start off your work using a low temperature setting and test to find out the most suitable temperature. The appropriate distance from the nozzle to the workpiece depends on the material you are working on. Removing varnishes, see Figure (A) For removing varnishes use the flat nozzle or the spatula nozzle . Do not apply heat for too long as this burns the varnish and makes removal more difficult. Where there is very little space in which to work, the thermal protective cover can be screwed off. Removing adhesives, stickers and adhesive residues Use the flat nozzle to remove adhesives. The glued items can then be separated and any residual adhesive removed. Shaping plastic pipes Use the reflector nozzle for shaping plastic pipes. Avoid buckling the pipe by filling it with sand and sealing both ends. Use the reflector nozzle for thawing water pipes and always warm the pipe from the frozen part outwards. It is extremely difficult to tell the difference between water pipes and gas pipes. Copper pipes have soldered joints and therefore are not to be heated above 200 0 C. Warm threaded connections with hot air and then the bolts can be easily loosened. in the bathroom, WC or kitchen can be considerably reduced by using hot air. If no amount of soaking with water is enough to remove old wallpaper - hot air can help. [. . . ] The equipment was produced with the greatest of care and underwent thorough testing before delivery. In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase (if available) to the closest service address. Damage caused due to improper handling as well as regular wear of the parts are not covered by this warranty. Beaver Electronic Services · The Lodge, Premier Business Park Long Street, Walsall · West Midlands, WS2 9DY Tel. : 0 19 22/72 55 54 · Fax: 0 19 22/72 54 17 WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]