User manual PARKSIDE KH 3042 AIR TOOL SET

[. . . ] Plug-in nipple Hose with valve connector, straight Trigger Blow gun Extension nozzle Please make sure you familiarise yourself fully with the way the device works before you use it for the first time and that you understand how to handle the device correctly. To help you do this please read the accompanying operating instructions. If you pass the device on to anyone else, please ensure that you also pass on all the documentation. [. . . ] Do not remove rating plates or labels - they are safety-relevant parts of the device. If you are inexperienced in the use of this type of device, you should seek out information or training to learn how to handle it safely. Failure to observe the safety advice and instructions could result in serious injury and / or damage to property. High working pressures can give rise to recoil forces that under certain conditions can result in danger from continuous loading. First disconnect the hose from the compressed air source and only then disconnect the compressed air supply hose from the device. This will ensure that the compressed air supply hose does not wave around or recoil in an uncontrolled manner. The use of accessories other than those recommended in the operating instructions could lead to you being in danger of injury. NOTE: Operate the product only with cleaned, condensate- and oil-free compressed air and never exceed the maximum working air pressure at the device of 8 bar. NOTE: The compressed air source must be fitted with a (filter) / pressure reducer so that the air pressure can be regulated. If the object is overfilled with air (air pressure too high): Press the deflator valve 3 to release some air. Press the lever of the valve connector 5 downwards and pull the valve connector 5 off the valve. NOTE: First disconnect the hose from the compressor and only then disconnect the compressed air supply hose from the device. This will ensure that the compressed air supply hose does not wave around in an uncontrolled manner. Using accessories: Press the lever of the valve connector 5 and insert the desired accessory 10 to 13 or the cap 9 into the valve connector 5 . Using the blow gun Screw an extension nozzle 8 on to the blow gun 7 . NOTE: First disconnect the hose from the compressor and only then disconnect the compressed air supply hose from the device. [. . . ] The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. [. . . ]