User manual PARKSIDE KH 3038 SCROLL SAW

[. . . ] Do not use electrical power tools in areas where there is risk of fire or explosion. Avoid touching earthed objects such as pipes, heating radiators, ovens or refrigerators with parts of your body. Do not allow other people, in particular children, to touch the electrical power tool or the mains lead. When not being used electrical power tools should be stored in dry conditions in a high or enclosed place, out of reach of children. [. . . ] The use of inserted tools and accessories other than those recommended by the manufacturer could lead to you being injured. Have your electrical power tool repaired at an electrical equipment repair specialist. This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. J Ensure that the scroll saw stands on a level, J Do not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a horizontal surface. Always work with the mains lead leading away from the rear of the device. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always switch on the electrical power tool before moving the workpiece against it. Do not cut moist materials or damp surfaces, Use only undamaged, defect-free saw blades 7 . Ensure that the teeth on the saw blade 7 point downwards before you mount it in the device. Before sawing, check the workpiece for foreign bodies such as nails etc. Injury and / or damage to property may result from the saw blade striking nails etc. Switch off the device before you remove any wood residue from around the saw blade. Any noxious dusts or vapours generated from sawing represent a risk to the health of the person operating the device and to anyone near the work area. Wear protective glasses, hearing protection, dust protection masks and protective gloves. J Avoid making any sharp changes in direction during sawing to prevent the saw blade from twisting or tearing. J Before starting the saw cut, drill a hole at a corner or internal cut-out in the workpiece and start sawing from the hole. The choice of saw blade depends on the thickness and type of material and the intended cut. Pull the mains plug out of the socket before you carry out any task on the device, Advice on use Pressure on to the saw blade. J Push the workpiece slowly and with minimum J Reduce the rate of advance when you are 10c from the inside through the slot in the blade guard 9 . From the outside of the blade guard 9 , place the guide plate 10b on to the screw 10c . [. . . ] Pull the mains plug out of the socket before you carry out any task on the device, This appliance is guaranteed for 3 years from the date of purchase. It has been carefully produced and meti-culously checked before delivery. Contact your service centre by telephone in case of questions pertaining to the warranty. This warranty applies only to the initial purchaser and is non-transferable. [. . . ]