User manual PARKSIDE KH 3035 IMPACT DRILL

[. . . ] It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working. Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury. [. . . ] Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. A) remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. General safety advice for electrical power tools B) Do not use an electrical power tool if its switch is defective. An electrical power tool that can no longer be switched on and off is dangerous and must be repaired. C) Pull the mains plug out of the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device. D) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. Do not allow the ventilation slots to become covered while the device is operating. Always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / poisonous dusts presents a danger to health for the tool operator and any persons in the vicinity. [. . . ] Have your device repaired only by qualified specialist personnel using original manufacturer parts only. If the plug or mains lead needs to be replaced, always have the replacement carried out by the manufacturer or his service centre. Clockwise rotation: j Push the rotational direction switch 7 to the right in order to drill and to screw in screws. Anticlockwise rotation: j Push the direction of rotation switch 7 to the left to slacken a screw or screw it out. [. . . ]