User manual PARKSIDE KH 3028 RANDOM ORBITAL SANDER

[. . . ] Introduction / General safety advice for electrical power tools General safety advice for electrical power tools wARNING!Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury. Noise and vibration data: Measured values for noise are determined in accordance with EN 60745. The A-weighted noise level of the electrical power tool are typically: Sound pressure level: 83 dB(A) Sound power level: 94 dB(A) Uncertainty K: 3 dB Wear ear protection! [. . . ] C) Pull the mains plug out of the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device. D) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. General safety advice for electrical power tools Use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. ½ In event of danger, immediately re½ Always run the power cable away from the appliance to the rear. Ensure that the material being ground and the grinder itself do not overheat. Grinding dust in the dust sack, microfilter, paper sack (or in the filter sack or filter of the vacuum cleaner) can ignite automatically under unfavour-able conditions such as flying sparks when metal is being ground. There is a par-ticular hazard if the grinding dust is mixed with paint or polyurethane residues or other chemical substances and the material being ground is hot after being worked on for a prolonged period. The working of materials that can produce harmful / toxic dusts presents a health risk for the operator and for people located in the close vicinity. When working for extended periods on wood and, in particular, materials that produce dusts that are hazardous to health, connect the appliance to an appropriate external suction device. provide for sufficient ventilation when working plastics , varnishes and paints. [. . . ] Always switch the rotary sander on before applying it to the material to be worked, then make contact with it. When operating the device you can select between intermittent or continuous operation mode To switch on intermittent operation mode: Press the ON / OFF switch 1 . to switch off intermittent operation mode: Release the ON / OFF switch 1 . Switching on continuous operation: Press the ON / OFF switch 1 , keep it pressed down and press the locking button 2 . [. . . ]