User manual PARKSIDE KH 3020 BELT SANDER

[. . . ] Any other use or modification to the device shall be considered as improper use Introduction / General safety advice for electrical power tools Check that all the items and accessories are present immediately after unpacking the device: 1 Belt sander PEBS 900 SE 1 Sanding belt 1 Dust collection box 1 Extraction adapter (for external vacuum dust extraction) 1 Fixed mounting kit 1 Operating instructions Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working. The PEBS 900 SE belt sander has full-wave electronics with additional control electronics, soft start with inrush current limiting. Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury. [. . . ] This precaution is intended to prevent you from unintentionally starting the device. D) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. When undertaking prolonged sanding of wood, and in particular when working on materials that give rise to dusts that are hazardous to health, the sander must be connected to a suitable external dust extraction device. Ensure that there is adequate ventilation when working on plastic, paint, varnish etc. The belt sander is designed for the dry sanding of large surfaces of wood, plastic, metal and plaster and painted surfaces. Sanding paints containing lead, some types of wood and metal for example may give rise to hazardous or poisonous dusts and represents a risk to the health of the person operating the device and to anyone near the work area. Never support yourself by placing your hands near or in front of the device or the workpiece surface. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. After sanding, lift the device from the workpiece before switching it off. When working always hold the device securely with both hands (see Fig. General safety advice for electrical power tools / Preparing for use J Switch the device off and allow it to come to A complete standstill before you put it down. J When taking a break from your work, before carrying out any tasks on the device itself (e. [. . . ] If the plug or mains lead needs to be replaced, always have the replacement carried out by the manufacturer or its service centre. It has been carefully produced and meti-culously checked before delivery. Contact your service centre by telephone in case of questions pertaining to the warranty. This warranty applies only to the initial purchaser and is non-transferable. [. . . ]