User manual PARKSIDE KH 3019 ANGLE GRINDER

[. . . ] Before reading, unfold both pages containing illustrations and familiarise yourself with all functions of the device. General safety advice for electrical power tools Careful handling and use of electrical power tools. The following pictograms are used in these operating instructions / on the device: Read instruction manual!Wear hearing protection, dust protection mask, protective glasses and protective gloves. [. . . ] The rotating attachment may snag when it comes into Contact with the surface and cause you to lose control of the device. Do not have the electrical power tool running while you are carrying it. Your clothing could become trapped by unintentional contact with the rotating attachment and the tool could be pulled into your body. The use of water or other liquid coolants could result in electric shock. This causes the electrical power tool (if not controlled) to move in the opposite direction to the direction of rotation of the attachment at the point of constraint. If, for example, a grinding disc is pinched or snags in a workpiece, this can cause the edge of the grinding disc to penetrate the workpiece, become trapped there and either free itself or kickback. Always use abrasive consumables approved for use with your electrical power tool. Abrasive consumables not approved for use with your electrical power tool cannot be adequately guarded and are unsafe. B) To ensure the highest level of operational safety, the disc guard cover must be attached to the electrical power tool and set in such a way that the smallest possible area of the abrasive consumable is exposed to A) Avoid snagging the cutting disc and do not use too much contact pressure. Overloading the cutting disc increases the load and the tendency of the disc to twist or snag in the cut, making kickback or disc breakage more likely. If the cutting disc is moving away from you at the point of constraint in the workpiece, then, in the event of a kickback, the electrical power tool and the rotating disc may be thrown towards you. C) If the cutting disc jams or you stop work for a while, switch the device off and hold it until the disc comes to a complete stop. Never attempt to pull the still rotating cutting disc out of the cut as this could cause kickback. General safety advice for electrical power tools d) Do not switch on the device if the cutting disc is in the workpiece. Allow the cutting disc to reach full speed before carefully continuing with the cut. Otherwise the disc could snag, jump out of the workpiece or cause a kickback. e) Support boards or workpieces whilst cutting to reduce the risk of kickback caused by a jammed cutting disc. The workpiece must be supported to both sides of the cutting disc and particularly near the cutting disc and at the workpiece edge. F) Be particularly careful when pocket cutting in existing walls or other areas where you cannot see what you are cutting into. The cutting disc plunged into the surface could cut through gas or water pipes, electricity cables or other objects and cause kickback. Special safety advice for working with wire brushes A) Bear in mind that wire brushes lose pieces of wire during normal use. Flying pieces of wire can very easily penetrate thin clothing and / or skin. [. . . ] You can also use abrasive consumables and tools complying with the following technical specification: Spindle thread: M14 Speed: min. Grinding discs for wood / masonry attached with hook and eye fixings Dimensions: ø 115 mm / 125 mm You can use the following cutting or roughing/ grinding discs with this device: Dimensions: ø 125 x 22, 2 mm to max. 000 rpm highest level of safety while using the device, ensure that the smallest possible area of the grinding or cutting tool is exposed to the operator at all times (see Fig. The disc guard cover 5 is there to protect the operator from pieces breaking off and accidental contact with the grinding or cutting tool. [. . . ]