User manual PARKINSON COWAN 1154803

[. . . ] The installation work must be undertaken by a competent person as stated in the gas safety (Installation & Use) regulations current edition. This appliance should be serviced by an authorised Service Engineer and only genuine approved spare parts should be used. All packaging, both inside and outside the appliance must be removed before the appliance is used. If the appliance is to be placed on a base, measures must be taken to prevent the appliance from slipping. [. . . ] Check for ignition If a burner will not light then you need to check the crown and cap positions. CLEANING THE HOB The hotplate Clean the hotplate top using a mild abrasive such as 'Cif'. You can remove the pan supports, burner caps and burner crowns to clean them. If any food spills during cooking you can place the pan on another burner to finish cooking. Then you can remove the dirty parts and clean them before the spill 'burns on'. You can remove any stubborn stains by scouring with a soap filled pad such as 'Brillo'. If you look after the burner crowns in this way they will stay reasonably clean. Aluminium based saucepans can leave shiny metal marks on the pan supports. Clean the pan supports regularly to remove the marks using a mild abrasive like 'Cif' with a soft scourer. For more stubborn marks you can use a soap-filled pad such as 'Brillo'. After cleaning the appliance parts, dry them thoroughly before you put them back. 21 CLEANING THE APPLIANCE OUTSIDE OF THE CLEANING THE FURNITURE GRILL AND OVEN DO NOT use abrasive cleaning materials, eg Hob Brite, Brillo pads or scourers on painted or printed finishes as damage may occur. Regularly wipe over the control panel, oven doors and appliance sides using a soft cloth and hot soapy water. All removable parts, except the grill pan handle can be washed in the dishwasher. Clean the outer and inner glass using hot soapy water or Hob Brite may be used with care. The foil is there to help keep the door cool, if it is damaged it will not work. Ensure that all parts are well rinsed and thoroughly dry before attempting to replace the outer door. 23 TO REPLACE THE OUTER GLASS 1. Holding the door panel with both hands, gently place the locators into the holes of the brackets at the bottom of the oven door. Push the top of the oven door panel towards the oven door, ensuring the screw location holes line up. Hold the panel in place with one hand and insert the cross head screws into the location holes with the other hand. Tighten the screws positively with a Pozidrive screwdriver before closing the oven door. Do not attempt to use the oven without the outer panel being in place. If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Force Centre who will be pleased to advise further. REPLACING THE OVEN LIGHT BULB The type of bulb required is a 300°C 25 watt small Edison Screw. CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE BULB. [. . . ] Mark off dimension B (see Fig. 4a) back from this line on the centre line of the bracket to locate the front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure the height from floor level to engagement edge on back of appliance, dimension 'C' of Fig. 4b. Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' + 3mm above floor level. Reposition appliance and check that top bracket engages into appliance back as shown in Fig. [. . . ]