User manual PANASONIC NE-2156-2

[. . . ] Please read these instructions completely before operating this oven and keep for future reference. When an outlet is not earthed, it is personal responsibility and obligation of the customer to have it replaced with a properly earthed outlet. vOLTAGE AND POWER WARNING The voltage used must be the same as specified on the microwave oven. Using a higher voltage than that which is specified is dangerous, and may result in a fire or other type of accident causing damage. [. . . ] While pressing Stop/Reset pad, press Prog pad until "PROG" and "P" appear. The level is indicated by a number followed by the word "bEEP". 3bEEP = loudest 2bEEP = middle 1bEEP = quietist 0bEEP = silent There are two options of the length of beep tone at the end of heating cycle. 1 = 3 beeps 2 = short beeps for 60 seconds The loudest level and 3 beeps are preset at the factory. The tone will sound at its loudness level and the loudness level "3" followed by the word "bEEP" will appear. "PROG" will start to blink and 1st Stage Heating Indicator "1" (the length of beep tone "3 beeps") will be indicated. Note: Repeating to press the pad "0" will lower the loudness all the way to silent. Example: To select short beeps for 60 seconds PAD INSTRUCTION Follow step 1-4 on page 9. Within three seconds after pressing Prog pad at step 4, press Number/Memory pad "0" once. Example: To read times of Number/Memory pad "3" at A side (6666 times used) PAD INSTRUCTION Open the door and leave it open. The times that the pressed Number/Memory pad has been used will appear. When you want to read the times of each pad at B side, press Shift (A/B) pad while the display is still showing the number of cycles in step 2. PAD INSTRUCTION Close the door while the display is still showing the number of cycles that each pad has been used. Example: To program cleaning Air Filter every 600 hours PAD INSTRUCTION Open the door and leave it open. Note: When "FILT" sign appears in Digital Display Window, remove Air FIlter and clean it with soapy water. To check the total number of hours used, x Open the door and leave it open. X The total number of hours used and "H" will appear in Digital Display Window. If the oven has been used for 20 hours, Note: If the oven cuts out after short operation, check if Air Filter is clean before calling an engineer. Disconnect the power cord from the wall socket before attempting installation. For stacking installation, you must use the PANASONIC Joint Plate which is enclosed with this unit. Combination of the unit for stacking is limited within only the following PANASONIC models: NE-1057, NE-1457, NE-1247, NE-1747, NE-1047, Projection on Joint Plate must face away from the oven. This oven monitors its operation and displays a Failure Code in Digital Display Window when a problem occurs. [. . . ] Using styrofoam containers for these foods will cause the styrofoam to warp. Other low temperature restaurant glass or plastic platters may crack or warp under similar conditions. AVOID METAL because it "bounces" the microwaves, causing uneven heating and sometimes even flashes, which may pit or mark the interior of the oven, the metal container or plate trim. For specific time, see each food category for appropriate heating techniques, plus necessary prepreparation of foods. [. . . ]