User manual PANASONIC CU-CE9LKE

[. . . ] OPERATION CONDITION Use this air conditioner under the following temperature range Temperature (°C) COOLING HEATING Max. INDOOR UNIT AND OUTDOOR UNIT This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Remove the batteries if the unit is not going to be used for a long period of time. New batteries of the same type must be inserted following the polarity stated to prevent malfunction of the remote control. For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. Operating the unit within the recommended temperature could induce energy saving. Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. dRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. FAN mode - To circulate air in the room AUTO mode - For your convenience · During operation mode selection the power indicator blinks. Unit selects operation mode every 30 minutes according to temperature setting, outdoor and room temperature. When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time. If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is SET resumed) by pressing . To ensure optimal performance of the unit, cleaning maintenance has to be carried out at regular intervals. Dirty unit may cause malfunction and you may see error code "H99". Dry the filters thoroughly under the shade, away from fire or direct sunlight. [. . . ] Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. [. . . ]