User manual PANASONIC CS-UW12GKE

[. . . ] ⷠDo not expose directly to cold air for a long period. ⷠTurn off the power supply and unplug if the unit is not used for a long period of time. ⷠThis air conditioner is equipped with a built-in surge protective device. [. . . ] If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Pb Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. This model is not suitable for 4 hours non-stopping operation in heating mode below -5°C. When the outdoor temperature is below -5°C and you use this model out of above conditions, the outdoor unit might be frozen up and stop operation for protection control. Replacement or installation of power plugs shall be performed by authorized/ qualified personnel only. The wires in this mains lead are coloured in accordance with the following code: The illustrations in this manual are for explanation purposes only and may differ from the actual unit. Wiring colour may vary depending on a country wiring code's standard. The appliance is not intended for use by young children or the infirm person without supervision. Young children should be supervised to ensure that they do not play with the appliance. ⷠCertain fluorescent lights may interfere with signal transmission. The retention period of batteries might be affected to be shorter because of the using times of the remote control, even less than one year. ⷠOnce auto mode is selected, the unit will operate at the standard setting temperature. Room temperature 23°C & above Below 23°C Below 20°C Operation mode Cool Dry Heat Standard setting temperature (+2°C) 25°C 27°C 22°C 24°C 21°C 23°C (­2°C) 23°C 20°C 19°C In heat mode, it takes a while for the unit to warm up. [. . . ] Clean the filter regularly for best performance and to reduce power consumption. If chemical cloth is used to wipe the unit, instruction for the cloth should be followed. The unit operates automatically when power is resumed after a power failure. [. . . ]