User manual PALSON NILO

[. . . ] Before filling, if the cleaner has run completely out of water, see paragraph 8 of the information. Allow the attachments to cool before changing them during use of the device. Any repair, including changing the power cord, must be carried out by a qualified technician. If the power cord becomes damaged, it must by replaced by the manufacturer, your aftersale service or similar qualified personnel in order to prevent hazards. [. . . ] To disinfect a particular area, place the steam cleaner over the area, no more than one centimetre away, and move it slowly above the surface. Use this procedure to disinfect surfaces in: toilets and bathrooms, areas where food is prepared, cushions, bed linen, rooms where pets sleep, etc. iNSTRUCTIONS FOR USE The Steam Gun has been designed primarily to clean hard surfaces and upholsteries that withstand high temperatures. It must not be used on soft plastics, wood without an insulating layer or cold glass. WARNING: On surfaces that have been treated with wax or certain unwaxed floors, the steam may dull the gloss. Do not use on wood surfaces without an insulating layer as this may cause the wood to granulate. we recommend performing a trial cleaning on an isolated part of the surface to be cleaned. Also check the manufacturer's instructions for the care and use of the object to be cleaned. ASSEMBLY AND USE Do not plug the unit into a mains socket until Step 7. WARNING: After each use, press the steam production button until all the pressure has been released before removing the safety cap. (After using for the first time, place the device upside down to fully empty the heater). Fill the water container, included with the attachments, with water to the marked line, in one go. NOTE: Never place detergents, alcohol-containing products, aromatic products or descaling products in the product as this may damage it or make it unsafe for use. Use the following guidelines to couple the straight injector, the hose and the fabric attachment: Align the single mark on the attachment with the single mark on the cleaner. Press the attachment into the jointed injector until it connects with the cleaner's structure. Turn it clockwise until the single mark on the attachment is aligned with the double mark on the cleaner. To use the jointed injector, align the single marks on the attachment and the cleaner, press the attachment into the jointed injector until it covers the circular seal (See page 6). Now turn it clockwise until the single mark on the attachment is aligned with the double mark on the cleaner. These two attachments can be applied to the (cleaner's) jointed injector, the straight injector and the extension hose. Chose the desired angle and then press the attachment into the hexagon-shaped end of the injector. [. . . ] To guarantee a long, trouble-free service life, rinse the heater with water once a month to remove any scale. With the gun unplugged and cold, pour in one measure of water, replace the safety cap and shake to remove any scale. Suggested uses for the attachments Brush Stove tops, joins between tiles, inside of rubbish bins. It is recommended that you use the hose and the cloth with the fabric attachment when used for clothing, upholstery and curtains. [. . . ]