User manual PALSON CITY

[. . . ] - Do not allow the power cord to hang over edges where children could reach them. - An electrical appliance must not be used if: the power cord is damaged. The iron has fallen to the floor and there are visible signs of damage. [. . . ] Repairs performed by inexpert people may be dangerous and give rise to significant hazards for the user. - A damaged or faulty power cord should only be replaced by the authorised technical service, as special tools are required. - The iron must be used strictly in accordance with these instructions. NO liability will be accepted for any damage caused by not following these instructions or by any incorrect use or handling. - This product must not be used by children or by other people without assistance or supervision if their physical, sensory or mental condition limits safe use of the appliance. Children must be watched to make sure that they do not play with the appliance. - If the power cord is damaged, it must be replaced by the manufacturer or its authorised technical service or by a qualified technician in order to avoid hazards. DIRECTIONS FOR USE: STEAM IRONING Filling with water: * Move the steam adjustment control down as far as it will go. * Hold the iron vertical so that the water filling hole is horizontal. This is particularly handy for removing creases from hanging fabrics, curtains, etc. * Plug the iron into the mains and wait until the temperature lamp turns off. DRY IRONING: * Move the steam adjustment control as far as it will go to the less coloured area (MIN. Move the steam adjustment control to "max" and empty any water that there may be in the tank. Then, move the steam variation control to "min" and leave the iron to cool. * When it is not being used, always stand the iron in vertical position, on its heel; this will protect the ceramic soleplate. Integral power cord storage: * For easy storage, the power cord can be wrapped around a holder. Do not pull too hard on the cord as this could damage the cord protector. * The iron works with a constant steam volume and this means that the steam pressure remains constant irrespective of the quantity of water in the tank. [. . . ] * The iron works with a constant steam volume and this means that the steam pressure remains constant irrespective of the quantity of water in the tank. * The first time that you use your iron, a small quantity of smoke may be given off. This is perfectly normal and stops after the iron has been operating for a few minutes. [. . . ]