User manual PALSON ARIZONA

[. . . ] Do not place clothes or hands inside the brush or in openings on the robot as this could result in injury. Use the exclusive robotic vacuum charger only; failure to observe this warning could result in fire, electric shock or personal injury. Do not over-bend the power cable or place weight on top of it as this could damage the cable or result in electric shock or fire. Do not place the device close to cigarettes, lighters, matches or any other heat sources, including combustible materials, petrol, solvents, etc. [. . . ] Application: Technical specifications of docking station This product, designed primarily for domestic use, hotel rooms or in small offices, is ideal for cleaning No. When you start the machine, a flashing power indicator means the battery level is low and the battery needs to be charged. Turn the fan around, release the two catches and open the cover for cleaning. Pull the tab on the right hand side towards you and the filter will appear. Clean the filter or insert a new one, press the semicircular bracket with one hand to release the filter mesh clips and remove the grill with the other hand to clean it or to replace it. Turn the container back around; to remove the mop, release the right and left clips on the bottom of the container (See figures 8 and 9). All parts must be replaced following the dismantling steps in reverse order. The robotic vacuum may not locate the docking station if there is an obstruction, the battery is low or in more complex situations. The docking station should therefore be placed in a wide open space, where possible. When the robot finishes cleaning, the battery will be very hot, meaning longer charging times Do not use the mop or pull bar on rugs or uneven floors. Remove the fan housing and clean the air intake/outlet using the cleaning brush. Operating guide Start/Stop Operating information Turn on the machine; when you press the Start/Stop button, the machine will start working, and pressing it again will turn the machine off. When you press " ", the current time number 88 will start flashing. Press any given day of the week, several days or all days to set the device to clean on any one, several days or every day of the week. Cleaning Setting continuous cleaning If you have a large house, you can use function " " (continuous cleaning), in which the robotic vacuum will start cleaning when fully charged and return to the docking station automatically before its battery is flat. The robotic vacuum will start cleaning automatically when the battery is charged (charging time is about 5 or 6 hours). Note: The continuous cleaning and scheduled cleaning functions cannot be used at the same time!Error display Speed selection If you are certain that there is an error with the device, with the remote control within range, press this function button on the remote. The screen will show an error code which you should be able to clear by following instructions in the troubleshooting section. Press "FAST" or "SLOW" to select either fast or slow cleaning. When the view function is in normal mode, press this button to turn the robot on or off. With the unit switched on, press this button to stop the device in the corresponding mode. [. . . ] The signal transmission is the only way to guide the robot to the docking station to recharge; therefore the path of the transmission signal must be clear and free from obstructions. The remote control must be used within a radius of 10 metres, otherwise you will not be able to operate the unit. The robotic vacuum may not locate the docking station when you press automatic recharge if there is an obstruction, the battery is low or in more complex situations. And the robot are Positive and negative The electrodepath must be free connected to charge upon contact, therefore the from obstacles while in use, which electrode recharge could have an impact on the recharge. [. . . ]