User manual PALSON ARABICA

[. . . ] Make sure that the cable is not in contact with the hot surface of the electrical appliance. Do not put the coffee maker on hot surface or near to fire to prevent it from being damaged. Do not use this electrical appliance for any other use than that what it is been designed for and keep it in a dry place. This appliance s not designed to be used by people (including children) with physical, sensory or mental disabilities or who have no experience or knowledge, except when supervised or have been given instructions on the use of the appliance by the person looking after them. [. . . ] Then put the filter holder into the electrical appliance in the "Insertar" and release the pressure flange (17), and place it inside the coffee maker turning it anticlockwise until it snaps shut. When the green light has come on, you should turn the pump control button to the lowest position, position "P". Note: If the green light turns off with the machine working, you should close the pump and stop making espresso coffee, as the machine is heating up. If the green light turns on again after a few seconds, you can continue to make coffee turning the pump control button to position "P". The green light will turn on and off to tell you when the water temperature is high enough. You should manually turn the I/O to the highest position, position "O", when the required amount of coffee has been obtained or when the colour of the coffee is slightly different. WARNING: Do not neglect the coffee maker when it is operating as you may have to intervene manually. When it finishes making the coffee, remove the filter holder clockwise, and then empty the coffee grounds pushing the filter with the pressure flange (17). First prepare the espresso with a big enough cup, and make sure that the steam selector is in the minimum position. Turn the coffee/steam button to the lowest position, position , and wait until the green light turns on. Note: If the green light turns off when the machine is working, you should turn the steam selector to the minimum position. Then turn the coffee/steam button to the highest position, position , and turn the pump control button to the lowest position, position "P". After 30 seconds, turn the coffee/steam button to the lowest position, position again. Wait until the green light turns on and turn the steam selector anticlockwise. Fill a jar with around 100 ml of milk per cappuccino you are going to make. Note: When you have to choose the size of the jug, bear in mind that the milk doubles its volume, so make sure that the jug is tall enough. Put the steam rod with the rubber nozzle a couple of centimetres into the milk. Note: Never turn the steam selector off abruptly, as the steam quickly accumulates in a short time and could cause a potential explosion. When you have finished, you can turn the steam selector to position "O". Note: Clean the steam outlet with a damp sponge immediately after making steam. The cappuccino is now ready, and you can sprinkle a little ground chocolate on top of the froth if you wish. Turn the I/O button to the highest position, position "0", to unplug the machine from the generator. [. . . ] The red light is going to turn one, and you should turn the pump control button to the lowest position, position "P". Make sure that the coffee/steam button is in the highest position, position , and wait for a moment. Turn the pump control button to the lowest position, position "P", and leave the water to run for a few seconds. Turn the coffee/steam button to the lowest position, position , and wait until the green light turns on. [. . . ]