User manual PALM GPS 3301 GETTING STARTED GUIDE

[. . . ] The Palm® GPS Navigator provides detailed maps, route planning, and voice navigation. the GPS Navigator uses TomTom NAVIGATOR software and maps on your device. To use Navigator, your device makes a wireless connection to the included GPS receiver using Bluetooth® wireless technology. The receiver then transmits information to the NAVIGATOR software that is displayed on your device screen. [. . . ] You should need to enter the passkey only the first time you establish a Bluetooth connection between your device and the receiver. My device does not seem like it successfully connected to the receiver after setup. If the setup process does not seem to work, try manually creating a partnership between your device and the receiver. 4 Select the GPS receiver from the device list, and then press Next (right action key). 5 Enter the four-digit passkey 0000 (four zeroes) on your device, and then press Next (right action key). 6 Check the Serial Port box, and then press Finish (right action key). Should I keep my device and the receiver connected to the vehicle power adapter while they are in use?If your device is fully charged, it can run for about four to five hours in the car. For longer trips, it is a good idea to keep the Vehicle power adapter connected to keep both your device and the receiver charged. This prevents the batteries from getting too low for the Bluetooth connection to function. Please read the following information to ensure safe use of the GPS Navigator. The Global Positioning System (GPS) is operated by the government of the United States of America and is subject to changes which could affect the accuracy and performance of this GPS equipment. Some vehicle codes restrict any object or material from being placed, displayed, installed, affixed, or applied upon the windshield or side or rear windows. Where such codes exist, when using this product, the suction cup mount pad should be used instead of attaching the mount directly to the vehicle windshield or side or rear windows. Palm is not responsible for any damages, fines, or penalties that may result from disregarding this notice. GPS is operated and controlled under the sole responsibility of the Government of the United States of America, which is responsible for its availability and accuracy. Any changes in GPS availability and accuracy may impact the operation of your GPS receiver. And Palm cannot accept any liability for the availability and accuracy of GPS. Use of devices with an antenna is prohibited on most aircraft, in many hospitals, and in many other locations. Use of a GPS receiver for navigation does not by any means substitute for the need to drive with due care and attention. Some newer-model vehicles may have a heat-reflective shield embedded in the windshield, which may prevent proper GPS signal reception if the receiver is placed behind the windshield. Place the receiver in a different position, or Place the receiver behind the rearview mirror, where many vehicles have an opening in the heat reflective shield, as indicated by a black outline. [. . . ] And found to comply with all the requirements of the EMC Directive 89/336/EEC as amended. Ground yourself when you're holding your device by simultaneously touching a metal surface that is at earth ground. For example, if your computer has a metal case and is plugged into a standard three-prong grounded outlet, touching the case should discharge the ESD on your body. Electrostatic discharge (ESD) can cause damage to electronic devices if discharged into the device, so you should take steps to avoid such an occurrence. [. . . ]