User manual PACKARD BELL ONETWO PW.U6Q

[. . . ] Servicing is required when the apparatus has been damaged in any way, has been exposed to rain or moisture, does not operate normally or has been dropped. You must unplug the power supply cord to disconnect the apparatus from the power supply. With this in mind, the socket-outlet should be located close to the apparatus and should also be readily accessible. No part of this manual may be reproduced or transmitted, in any form or by any means, whether electronic, chemical, manual or otherwise, including but not limited to photocopying, recording, or information storage and retrieval systems, for any purpose without prior written permission of Packard Bell B. [. . . ] You can browse the content of the USB device using the Navigation buttons. Press the Open/Close button on the front panel of the unit to open the tray. Use the Navigation buttons to navigate in the menu and press Play/OK to make selection. Press the Play/OK button twice to access the setup menu during playback. Use the and buttons to highlight the A-B REPEAT item, press the Play/OK button to mark the start point (A); press the Play/OK button again to display the A-B REPEAT item and then press the Play/OK button for the third time to mark the end point (B). Then the section between the start point and end point will be repeatedly played. Title/chapter/disc repeat - Repeatedly press the Repeat button during playback to repeat title/chapter/disc. Press AUDIO repeatedly to toggle between up to 8 audio languages or sound when the disc is recorded with multi-languages. For Karaoke discs, press AUDIO button to switch between the accompanying music and vocal. Press SUBTITLE repeatedly to toggle between up to 32 subtitle languages when the disc is recorded with multi-subtitles. Press ANGLE repeatedly to toggle between up to 9 viewing angles when scenes recorded in the disc was shot with multiple cameras from different angles. You can issue FF, FR, Pause, Play commands for the camera using the Easy HDD Recorder remote control. You cannot change the channel or the source if a recording is active (if the end of the recording segment has not been entered, or in the case of long recording, it has not been reached). If you attempt to change the channel or source, the Easy HDD Recorder will prompt you to stop recording. The segment will be saved on HDD and then the channel or source will be changed. Several minutes before the time recording event begins, a dialogue box will appear on your TV screen prompting you to confirm or cancel the event. If you do not make any selection, the timer recording will proceed as scheduled. If the recorder is in standby status, it will automatically power on two minutes before the start of the time recording event. a recordable DVD disc can record 360 minutes of programs (SLP quality). Because DVD±R discs cannot be repeatedly recorded or edited, the operations mentioned below do not work on these discs. Insert a DVD+RW or DVD-RW disc with recorded contents into the disc tray. If button to view the and Overwrite title - To replace a previously dubbed session with newly recorded contents, overwriting the session. [. . . ] You should choose the correct standard according to the local TV signal. Search type: Select the type of scan to be used when performing a scan for TV channels. Use the and buttons to highlight either the Audio, Subtitle or Disc Menu items and press the Play/OK button. Use the and buttons to highlight the desired language and press the Play/OK button to confirm. [. . . ]