User manual OSTER OGG61403

[. . . ] · Be sure your Microwave Drawer is installed and grounded properly by a qualified installer or service technician. · Remove the feature sticker, if there is one. Oven Check the drawer for cavity any damage, such as misaligned or bent drawer, damaged drawer seals and sealing surfaces, broken or loose Microwave Drawer guides and dents inside the cavity or on the front side of the drawer. If there is any damage, do not operate the Microwave Drawer and contact your dealer or a OSTER AUTHORIZED SERVICER. Sealing surface IMPORTANT SAFETY INSTRUCTIONS If the information in this manual is not followed exactly, a fire or electrical shock may result that could cause property damage, personal injury or death. [. . . ] · Make sure the wall coverings and the cabinets around the Microwave Drawer can withstand the heat generated by the Microwave Drawer. IMPORTANT NOTES TO THE INSTALLER · Remove all packing material before connecting the electrical supply. · Read all of the Installation Manual before installing the Microwave Drawer. Never leave children alone or unattended in the area where a Microwave Drawer is in use. Stepping, leaning or sitting on the drawer may result in serious injuries and can also cause damage to the Microwave Drawer. This creates a potentially hazardous situation. · Check that the time-of-day is in the display. If not, touch Stop/Clear to prevent unintended use. 1 CLEARANCES AND DIMENSIONS · Dimensions that are shown in Figure 1 (for 24") or Figures 3 and 4 (for 30") must be used. Locate electrical outlet in the shaded area in the upper left-hand corner of the cutout. · Check location where the Microwave Drawer will be installed for proper electrical supply. · Your oven can be built into a cabinet or wall by itself or under a gas or electric wall oven. and the microwave drawer is a minimum of 2-inches. · Contact surface must be solid and level. It must be plugged into a wall receptacle that is properly installed and grounded. Should you only have a 2-prong outlet, have a qualified electrician install a correct wall receptacle. Note: If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service person. 2. Avoid pinching the cord between the oven and the wall. 4 Screws Figure 8B 3. Slide the drawer all the way until the mounting flange is flush with the face of the cabinet. Using the 4 holes on the drawer as a template, pre drill the cabinet using a 1/16" bit. See Figure 8B. GROUNDING INSTRUCTIONS This appliance must be grounded. The Microwave Drawer is equipped with a cord having a grounding wire with a grounding plug. [. . . ] The Microwave Drawer is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of Permanent and Correct Installation an electrical shor t circuit, 3-Prong plug grounding reduces r isk of electric shock by providing an escape wire for the electric current. [. . . ]