User manual ORIENT CDB05001B0

[. . . ] 1 A watch with water resistance for daily life 30M (3 bar) can be used during face-washing, etc. But cannot be used in an environment in which it will be submerged in water. 2 A watch with reinforced water resistance for daily life I 50M (5 bar) can be used while swimming, etc. 3 A watch with reinforced water resistance for daily life II 100M or 200M (10 or 20 bar) can be used while skin diving, but cannot be used while scuba diving using oxygen tanks or saturation diving using helium gas, etc. [. . . ] Searching by 10-digit model number Check the 10-digit model number on the guarantee supplied with your watch. Its second and third digits indicate the caliber number of your watch. Example: If the model number is "CDB05001B0", the caliber number is "DB". Searching by the case code See the case code on the case back of your watch. Search the caliber number corresponding to the movement number referring to the correspondence table. Example A : When the case code is "DB05-C0", the caliber number is "DB". Example B : When the case code is "469396-81", the movement number is "469". The caliber number corresponding the number will be found "EM" on the table. * The place of case code may vary and its letter size may be small and difficult to see depending on the characteristics of watches. * The pictures and illustrations on this manual may differ from the actual appearance of your watch but the function and operation procedures are the same. (1) Vibrations: 21, 600 vibrations/1 hour (2) Number of jewels: 21 jewels (3) Running time: More than 40 hours (4) Shock-proof bearings to protect the balance with hairspring from shocks. the stated daily accuracy is in the following coditions: · After 24 hours at room temperature with the mainspring wound fully and the dial facing up. ⷠDue to the characteristics of the automatic winding watch, the time may deviate from the stated "daily accuracy" depending on the following conditions: amount of time the watch is worn each day, position of the watch, movement of your arm, winding condition of the mainspring. * Avoid setting the date during the time periods listed in "Remark1" above since the calendar changes during this time. If the date is set during this time period, the date may not change or the watch may malfunction. Be sure to move the hour and minute hands away from this time period when setting the date. * The position of the crown, date indicator, or day of the week window may be different, depending on the model. (1) The mainspring is wound by natural movements of your arm when wearing the watch on your wrist. (2) If your watch stops, swing the watch back and forth ten or more times to re-start the second hand. (3) This watch will run approximately 40 hours after it is fully wound. [. . . ] ) are aligned with the section that does not have the days of the week printed on the dial (3 - 4 o'clock side), days of the week will not be indicated at the end of the month. You can easily use the calendar for the year Example 1: printed on the rotating ring by operating the crown. Depending on the model, the month on the Month six o'clock side may be printed in roman numerals or alphabet. Example 1: To set October 2007 (1) Turn the crown and set "07" on the rotating Rotating ring: ring to "OCT" on the six o'clock side. [. . . ]