User manual OREGON SCIENTIFIC SL928D

[. . . ] [ MODE ] BUTTON Changes an operating mode or enters a setting procedure D. [ START/STOP ] BUTTON Starts or stops the stopwatch, timer or pacer, changes or increases a value E. [ RECALL ] INDICATOR Indicates the RECALL function is active F [ LAP ] INDICATOR . [. . . ] The free memory remained will be shown on the display when a segment is registered. Chronograph mode can be run at the background when the stopwatch is started and go to the other display mode. Stopwatch function operates even, if all segment and lap memory is used up. HOW TO SELECT THE CHRONOGRAPH IN UNITS OF HOURS, MINTUES OR SECONDS Refer to (FIG. Four different chronograph units of display: hour:minute:second with 1/100 sec. resolution; hour with 1/100000 hr resolution and minute with 1/1000 min resolution. Within each segment it is allowed only one single unit of display. HOW TO RECALL CHRONOGRAPH RECORDS Refer to (FIG. The last recorded segment will be displayed with its time and date stamp when advance from chronograph mode. Two beeping sounds will be heard to indicate the end of lap record for each segment. HOW TO ERASE CHRONOGRAPH RECORDS Refer to (FIG. Note: The record of the current running chronograph cannot be deleted. 4 HOW TO USE THE TIMER Refer to (FIG. There are three modes of operation that can be chosen : CS (count down and stop), CU (count down and count up) or CR (count down, automatic reload and repeat). The maximum count down or count up time is 23 hours, 59 minutes and 59 seconds. A pre-alert tone will be emitted at five second before completion of a count cycle and an alert tone will be emitted for 10 sec. Once started the Timer can be running in the background even if the unit is in a different display mode. HOW TO USE THE PACER Refer to (FIG. number of beeping sound to be heard will be range from 30 beep per minute to 240 beep per mintue. Beeping sound will be heard and flashing "PACER" icon will be seen during the stopwatch running mode if pacer is activated. HOW TO USE THE DAILY ALARM Refer to (FIG. The alarm will be automatically activated during the setting procedure. Press any key to mute the tone. 5 GB GB AUTO RETURN In all setting procedures, the unit will automatically save all changes and return to the previous operating mode if no button is pressed for 30 seconds. HOW TO USE THE SAFETY CORD Refer to (FIG. Loop and tighten the cord until it is in place. BATTERY INFORMATION Refer to (FIG. [. . . ] Upon return of the defective product, Oregon Scientific will at its discretion, replace the product with either a new or a tested reconditioned product. Should the product be out of warranty, the consumer may purchase directly from Oregon Scientific a replacement at reasonable cost plus shipping and handling. 7 GB GB GB LEGEND : ITALIC ITALIC - PRESS - PRESS & HOLD FOR 2 SEC. - FLASHING - FAST ADVANCE F LEGENDE : ITALIQUES ITALIQUES - APPUYER - APPUYER PENDANT 2 SEC. [. . . ]