User manual OREGON SCIENTIFIC RM813P-E

[. . . ] Note that this switch can only be used with the power adapter installed. For momentary projection, use the [ SNOOZE ]. HOW TO USE THE PROJECTOR Press [ SNOOZE ] and the projection will be activated for approximately 5 seconds. Note: Make sure the [ front. PROJECTION ON ] switch is switched to the ABOUT RADIO RECEPTION RM813P/RM813PU is designed to synchronize its calendar clock automatically once it is brought within range of the Frankfurt DCF77 radio signal (MSF60 for UK version). [. . . ] Thursday Friday Saturday Sunday Interference English Reception can be affected by a number of factors. For best reception, place the device away from metal objects and electrical appliances. Note: Interference from sources such as TV sets can affect the signal. If, after batteries have been inserted for ten minutes, the signal is not received, then set the time manually (see section: How To Set The Clock & Calendar Manually). German French Italian Spanish HOW TO SET THE CLOCK AND CALENDAR MANUALLY To set the clock and calendar: 1. Press and hold [MODE] for 2 seconds and the time-zone offset hour digits will blink. Enter the value by [ ]/[ ] buttons. Please note that in order to use the clock in different time-zone, 2nd time-zone offset hour has to be set. +1), the time displayed will be the RF clock time plus 1 hour. 4 3. Follow the same procedures to set and activate the Single and/or Weekday Alarm. HOW TO DEACTIVATE THE ALARM To deactivate the alarm: 1. " -:-- " will be displayed when the alarm is being deactivated. HOW TO SET AND ACTIVATE THE ALARM This unit is equipped with 2 alarms: Single Alarm [ ] and Weekday Alarm [ ] . For the Weekday Alarm, it will be enabled from Monday to Friday and disabled automatically during weekend (i. e. , Saturday and Sunday). To activate the alarm again, press [ alarm is in display. ]/[ ] buttons when such CRESCENDO ALARM AND SNOOZE FUNCTION When the alarm goes off at the preset time, the projector will be turned on for 8 seconds. The respective ALARM ON icon [ ] or [ ] will be flashing and the alarm sound will be turned on. The crescendo alarm function allows the alarm sound to start off gently with step-up intensity. Without interruption, the alarm will go off for 2 minutes. GB GB To stop the alarm, press [ ] or [SNOOZE]. If [SNOOZE] button is pressed, the alarm sound will be turned off temporarily and the snooze function will be activated. 8 minutes until other key is pressed to turn off the alarm. HOW TO CHANGE THE GUIDING LIGHT BULB RM813P/ RM813PU is pre-installed with a 3V lightbulb. In case you want to change the lightbulb follow the instructions below: 1. Remove the tail of the unit as shown. RESETTING THE UNIT In case of malfunction or abnormal display, press the [RESET] button at the bottom of the unit wth a blunt stylus. [. . . ] If the unit comes in contact with water, dry it immediately with a soft lint-free cloth. Abrasive cleaning agents may scratch the plastic parts and corrode the electronic circuit. Do not subject the unit to excessive: force, shock, dust, temperature, or humidity. [. . . ]