User manual OREGON SCIENTIFIC RM336PES REV 1

[. . . ] : rechargeable battery level indicator : AC adapter connected : outdoor remote sensor battery low / main unit back-up batteries low / no battery Rechargeable battery status LED indicator SLEEP PROJECTION: sleep projection function is ON PROJECTION: appears when selecting alarm projection option (ON/OFF) : daily alarm is ON : alarm time is displayed SlEEP : enable continuous projection; activate projection sleep timer; adjust timer settings (0, 5, 30, 45, 60 minutes) SOlAR PANEl This product uses two AAA rechargeable batteries which should be charged via the solar panel. For the batteries' first charge, it is strongly advised to charge it for at least 2 hours. [. . . ] NOTE Time zone offset sets the clock +/- 23 hours from the received clock signal time. If you have deactivated the clock signal reception, do not set a value for time zone. NOTE If you enter + in the time offset setting, this will give you your local time plus one hour. If signal reception is unsuccessful, place your unit next to a window, press and hold + to force another signal search. TiP When the alarm setting option of PROJECTION ON has been selected, the projection feature will be activated 5 minutes before the set alarm time and will remain on until the alarm is turned off. Press SNOOZE to silence it for 8 minutes (the projection will also remain on during this time) OR · Press any key to turn the alarm off and activate it again after 24 hours. Rotate projection head SlEEP PROJECTiON TiMER To activate sleep projection timer: · NOTE If the adapter is connected and PROJECTiON switch is in ON position, the projection will remain on despite sleep timer having reached "0". NOTE To conserve energy, the installed light sensor inside the unit will disable the continuous projection feature when it detects a certain level of brightness in the surroundings. When disposing of this product, ensure it is collected separately for special treatment. Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. consult the furniture manufacturer's care instructions for information. The contents of this manual may not be reproduced without the permission of the manufacturer. [. . . ] WARNiNG Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 8 Operation is subject to the following two conditions: ) This device may not cause harmful interference. [. . . ]