User manual OREGON SCIENTIFIC RM308P

[. . . ] Collection of such waste separately for special treatment is necessary. Remove the strip from the battery compartment before first use. If the signal is weak, it can take up to 24 hours to get a valid signal. [. . . ] NOTE The language options are English (E), German (D), French (F), Italian (I), and Spanish (S). Asp 2 3 1 1 FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 2 3 PAESI CONFORMI ALLA DIRETTIVA R&TTE 2 3 To silence the alarm: • Press SNOOZE / LIGHT to silence it for 8 minutes OR • Press any other key to turn the alarm off and activate it again after 24 hours. FOCUS: focus the projected image RESET: reset unit to default settings PROJECTION ON/OFF: enable / disable continuous projection AC adaptor socket To select display mode: • Press MODE to toggle between displays (alarm, calendar with seconds and calendar with weekday). NOTE If projection is illuminated, do not look directly into the projector. MEANING Battery is low in power No battery installed – only AC adaptor 1 x adaptor Alternatively, use the adaptor supplied to power the unit. Make sure the adapter is not obstructed and is easily accessible to the unit. NOTE The main unit and adaptor should not be exposed to wet conditions. [. . . ] : RM308P / RM308PA / RM308PU / RA308PH Product Name: Classic dual-alarm projection clock Manufacturer: IDT Technology Limited Address: Block C , 9/F , Kaiser Estate , Phase 1 , 41 Man Yue St. , Hung Hom, Kowloon, Hong Kong is in conformity with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. [. . . ]