User manual OREGON SCIENTIFIC RAR186

[. . . ] 8 Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Set Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Insert batteries before first use, matching the polarity as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press MODE to confirm. on a wall with a nail. REMOTE SENSOR (THN122) This product is shipped with a THN122 Thermo Sensor that collects Temperature data. SETUP SENSOR TABLE STAND OR WALL MOUNT Product can stand on detachable base or be mounted Open the remote sensor battery compartment with a 6 small Phillips screwdriver. Insert the batteries, matching the polarity as shown in the battery compartment. The switch is located in the battery compartment. temperature unit before you mount the sensor. · Do not place the sensor more than 30 meters (98 feet) from the main (indoor) unit. · Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture. · Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects. · Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission. You may need to experiment with various locations to get the best results. DATA TRANSMISSION Data is sent from the sensor(s) every 30 seconds. Place the sensor near the main unit. Press RESET on the sensor to initiate signal sending between the sensor and the main unit. If you are using more than one sensor, select a different channel for each sensor. the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Sensor Data Transmission section for more information. ) 4. Secure the sensor in the desired location using the wall mount or table stand. · Insert the batteries and select the channel and For best results: 7 EN EN The reception icon shown in the Temperature Area shows the status. SEARCH FOR SENSOR To search for a sensor, press and hold MEM and ICON DESCRIPTION Main unit is searching for sensors. [. . . ] Unauthorized changes may void your right to product and contents of this user specification of this use the product. Images not drawn to scale. Trend ICON Rising Steady Falling RESET SYSTEM The RESET buttons are located in the battery compartments for the main unit and sensors. Press RESET when you change the batteries and whenever performance is not behaving as expected (for example, unable to establish radio frequency link with remote sensor. [. . . ]