User manual OREGON SCIENTIFIC RA201

[. . . ] OUTBREAKER USER'S MANUAL MODEL: RA201 CONTENT Table of figures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Legends. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SECTION 1: ATTENTION!. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press any key to stop the alarm. + SET SET - + - + - SET SET CHRONOMETER It could be used as a stopwatch as well as a countdown timer. Press ST/SP to start or stop the stopwatch in clock-chronometer display. 10 Set hour Set minute Set Second Fig. 3d Notes: a) This chronometer works independently with the chronometer in sailing timer mode. c) If the chronometer is used as a timer, after reset it will go back to set time in the timer mode. The chronometer could be used as a stopwatch unless the time display shows 00:00:00. d) After the countdown timer count to 00:00:00, it will start count up as a stopwatch automatically. SELECT Altitude alarm Temperature SELECT SELECT SELECT SELECT SECTION 3 ALTIMETERBAROMETER MODE RA201 is equipped with an intelligent barometer that determines altitude by the built-in sensor with the advanced Bar-compensation technology, the sensor can also distinguish the differences between pressure caused by changes in physical altitudes or pressure caused by weather conditions. This smart distinction eliminates discrepancies and makes the altimeter reading more accurate than most of the average devices available on the market. Note: Sea level pressure Local pressure Fig. 4 · There is a bar graph at the bottom of the display showing the altitude history. Press and hold SET for two seconds in altitude-clock display to enter the altitude setting mode. Press SET to confirm the setting and toggle to next field and then quit the setting mode. INFORMATION SHOWN IN ALTIMETER Five information can be shown in altimeter: clock, altimeter alarm, temperature, local pressure, and sea level pressure. Refer to Fig 4 to toggle between the information in altimeter mode. 11 GB GB Refer to Fig 4a to set the altitude. + Set altitude - Set resolution HOW TO SET THE RESOLUTION OF ALTITUDE Resolution of altitude can be set in the sequence of setting the altitude. Press and hold SET for two seconds in altitude-clock display to enter the altitude setting mode. Note: SET SET +/- SET Fig. 4b · Press and hold +/- function is not available for select the resolution of altitude. Fig. 4a Notes: a) The correct local altitude could be found from a topographical map. For details please refer to section HOW TO SET THE SEA LEVEL PRESSURE. HOW TO SET THE ALTITUDE ALARM RA201 is equipped with an altitude alarm. the ascending altitude alarm will be turned on whenever the set altitude is reached during ascending from an ascending path. The descending alarm will be turned on whenever the set altitude is reached during descending from a descending path. Press and hold SET for two seconds in altitude-altitude alarm display to enter the altitude alarm setting mode. Refer to Fig 4c to set the altitude alarm. Set acsending/descending alarm HOW TO SET THE WEATHER FORECAST ICON Apart from determining the altitude, barometer also forecasts the weather for the forthcoming 12 to 24 hours based on barometric pressure changes. To have a faster response of the weather forecast, it is suggested to set the weather forecast icon to match the current weather. The forecast will automatically be displayed in one of the four icons: Indicator displays on the unit Forecast Sunny Slightly cloudy Cloudy Rainy SET +/- SET - + - SET 1. Press and hold SET for two seconds in altitude-local pressure display to enter the weather forecast icon setting mode. Press SET to confirm the setting and then quit the setting mode. Set altimeter alarm on/off Set altitude Fig. 4c Notes: a) Press any key to stop the alarm sound, however, if the set value is reached again, the alarm will be re-activated with respect to the status. [. . . ] · Do not expose the unit to excessive force, shock, dust and temperature or humidity. Such treatment may result in malfunction, shorter electronic life span, damaged batteries, or distorted parts. Press and hold LIGHT/ key lock function. Note: for two seconds to activate/release the · Do not tamper with the unit's internal components. Doing so will terminate the unit's warranty and may cause damage. [. . . ]