User manual OREGON SCIENTIFIC PMP238

[. . . ] The PMP238's trouble-free qualities are enhanced through the product's small size, it's lightweight, and pillbox design. 7. [ ADV] Button - Activates EL back light - Increases values when setting the clock or timer C. [PULSE] Button - Sets the unit in pulse-display mode - Returns unit to a previous mode from Pulse mode D. [MODE] Button - Alternates between clock and timer displays - Initiates settings changes E. [. . . ] The unit will count down from a maximum time of 29-hours, 59-minutes to zero. In count-down timer mode, once the unit reaches zero it will stop and an alarm will sound. Note: If the clock is displayed, press [MODE] to enter the timer mode. From pulse mode, press [PULSE] to exit followed by [MODE] to toggle between clock and timer displays. Note: If no buttons are pressed for 60-seconds during the timer-setting function, the unit will automatically exit the timer-setting mode. Note: - When the timer reaches 0:00:00 a beeping alarm will activate to indicate that the timer has completed its cycle. After one minute, the alarm will continue to make one short beeping sound once every two-minutes. To stop the alarm, press any button and the timer will automatically reset to the original timer setting. - When the timer is active, the timer icon will appear and be flashing on the pulse-mode display and the clock display. The timer will pause until [ST / SP] is pressed again. To clear the timer: 1. To reset the timer to its originally set time: - Press and hold [ST / SP] for 2-seconds. THE PULSEMETER A person's pulse rate indicates the number of times that the heart beats within a given amount of time. Monitoring pulse rate can be useful for determining appropriate medication. In either clock or timer display, press [PULSE], the display will show a heart . GB GB 2. Position your right index finger so that the padded portion over the pulse sensor . THE ELECTRO-LUMINESCENT BACKLIGHT The electro-luminescent (EL) back light illuminates the LCD for easy nighttime viewing. The LCD will illuminate for approximately Press [ 5-seconds. Sensor 3. Maintain a steady position, holding too forcefully or too lightly may result in an incorrect reading. Note: When your finger is positioned properly, the heart icon on the display will flash. [. . . ] -- The manufacturer and its suppliers held no responsibility to you or any other person for any damage expenses, lost profits, or any other claim arise by using this product. -- The contents of this manual may not be repro duced without the permission of the manufacturer. SPECIFICATIONS Operating modes : Clock mode, timer mode and pulse mode Real -time clock Timer Pulse range Power source Dimensions Weight : 12 hour / 24 hour with hour, minute and second display : Maximum, 29 hours, 59 minutes : 40 to 237 bpm : 1 x CR2032 3V lithium cell : 16 (D) x 56 (W) x 88 (L) mm : 37. 5 g (approximate) WARRANTY This product is warranted to be free of defects in manufacturing for 90 days after purchase. For technical support please call 800-853-8883 (Monday - Friday, 8am-5pm PST). Defective product returns should be directed to the place of retail purchase. [. . . ]