User manual OREGON SCIENTIFIC JD THT312 DIGITAL CLOCK

[. . . ] Drive a screw (not included) along with wire attachment into the wall at the location you choose for the external sensor. Route the outdoor sensor cord (3 meters or 10 feet) and main unit to the desired location. CAUTION The contents of this manual is subject to change without further notice. Due to printing limitations, the displays shown in this manual may differ from the actual display. The contents of this manual may not be reproduced without the permission of the manufacturer. is in conformity with Part 15 of the FCC Rules. [. . . ] Toggle the [ALARM ON/OFF] key on back of product to enable/disable alarm function. ] on the display will indicate alarm is OUTDOOR SENSOR PROBE COUNTRIES RTTE APPROVAL COMPLIED All EC countries, Switzerland CH and Norway H FEATURES · · · · · · · · · Three line LCD display, shows clock, indoor & outdoor temperature. 5-second backlight delay Desktop or wall mount feature. NOTE A bell icon [ activated. ABOUT THE LIGHT & SNOOZE FUNCTION 1. When the [LIGHT/SNOOZE] button is pressed, the backlight will stay lit for 5 seconds before turning off if no key is pressed. When alarm sounds the backlight will come on automatically and pressing the [LIGHT/SNOOZE] button will activate the snooze function. 2. MAINTENANCE When handled properly, this unit is engineered to give you years of satisfactory service. If the unit comes in contact with water, dry it immediately with a soft lint-free cloth. Abrasive cleaning agents may scratch the plastic parts and corrode the electronic circuit. Do not subject the unit to excessive force, shock, dust, temperature, or humidity. Such treatment may result in malfunction, a shorter electronic life span, damaged batteries, or distorted parts. Doing so will terminate the unit's warranty and may cause damage. Read this instruction manual thoroughly before operating the unit. FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio / TV technician for help. HOW TO STOP THE ALARM When alarm sounds, press any button (expect [LIGHT/ SNOOZE] button) to stop the alarm. DISCRIPTION OF PARTS LCD DISPLAY 12/24. [. . . ] 19861 SW 95th Ave. , Tualatin, Oregon 97062 USA 1-800-853-8883 1-503-684-3332 HOW TO SELECT THE TEMPERATURE UNIT OF MEASURE The thermometer can select between degrees Celsius and Fahrenheit readings by sliding the [°C /°F ] button up for degree Celsius and down for degree Fahrenheit. NORMAL MODE HOW TO INSTALL AND REPLACE BATTERY The Thermometer uses two pieces of UM-4 or `AAA' size batteries. Remove battery cover on the back of the unit by gently pressing down on the arrow and slide in the direction it is pointing. Be sure to follow the polarity symbols as marked inside the battery compartment. Replace the battery cover. HOW TO SELECT THE HOUR DISPLAY FORMAT The clock can be either in a 12 or 24-hour format depending on the format selected by user. [. . . ]