User manual OREGON SCIENTIFIC BAR638HG WIRELESS WEATHER STATION

[. . . ] 6 Set Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Activate Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Silence Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Weather Forecast . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If you are using more than one sensor, select a different channel for each sensor. 3. Then, press and hold MEM and CHANNEL on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the "Data Transmission" section for more information. ) 4 BAR638HG_M_EN_6. p65 4 2005. 4. 27, 10:56 PM 5. Secure the sensor in the desired location using the wall mount or table stand. NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location. NOTE Signals from household devices such as doorbells, electronic garage doors, and home security systems may cause temporary reception failure. The reception will resume once the interference ends. CLOCK The clock automatically synchronizes the current time and date when it is brought within range of the radio signal DCF77 generated from Frankfurt, Germany for Central Europe (model BAR638HG / BAR638HG-2) or MSF60 generated from Rugby, England (model BAR638HGU / BAR638HGU-2). NOTE The signals are collected by the main unit when it is within 1500 km (932 miles) of a signal. Initial reception takes 2-10 minutes, and is initiated when you first setup the unit, and whenever you press RESET. STRONG SIGNAL WEAK SIGNAL NO SIGNAL For best results: · Insert the batteries and select the channel before you mount the sensor. · Do not place the sensor more than 30 metres (98 feet) from the main (indoor) unit. · Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture. · Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects. · Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission. You may need to experiment with various locations to get the best results. DATA TRANSMISSION Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature and Humidity Areas show the status. Channel 1 is selected (number will change depending on the sensor you select). --- shows in Outdoor The selected sensor cannot Temp / Humidity Area be found. [. . . ] NOTE The technical specification of this product and contents of this user guide are subject to change without notice. Weight REMOTE SENSOR DIMENSIONS LxWxH 92 x 60 x 20 mm (3. 6 x 2. 4 x 0. 79 inches) 63 grams (2. 22 ounces) without battery Weight TEMPERATURE Unit Indoor range °C / °F -5°C to 50°C (23°F to 122°F) -20°C to 60°C (-4°F to 140°F) 0. 1°C (0. 2°F) Outdoor range Resolution TROUBLESHOOTING RELATIVE HUMIDITY PROBLEM SYMPTOM Calendar Clock Strange date / month Cannot autosynchronize the date and time REMEDY Change language Range Resolution Memory 25% to 95% 1% Minimum / maximum Cannot adjust clock Disable clock 1. Manually activate clock feature WEATHER FORECAST Display Rainy, cloudy, partly cloudy, sunny REMOTE SENSOR (THGR122NX) RF frequency Range 7 433 MHz 30 metres (98 feet) with no obstructions BAR638HG_M_EN_6. p65 7 2005. 4. 27, 10:56 PM EN EN Transmission Channel No. Every 40 seconds 1-3 EC-DECLARATION OF CONFORMITY Hereby, Oregon Scientific, declares that this Wireless Weather Station BAR638HG/BAR638HG-2/ BAR638HGU/BAR638HGU-2 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service. CLOCK RF Clock Clock display Hour format Auto or manual (disabled) HH:MM:SS 12hr AM / PM (Model BAR638HGU / BAR638HGU-2) 24hr (Model BAR638HG / BAR638HG-2) DD / MM; weekday in 5 languages (E, D, F, I, S) Single alarm with 2-minute crescendo and 8-minute snooze Calendar Alarm POWER Main unit batteries Sensor batteries 3 x UM-3 (AA) 1. 5V 2 x UM-4 (AAA) 1. 5V NOTE It is recommended that you use alkaline batteries with this product for longer performance. ABOUT OREGON SCIENTIFIC Visit our website (www. oregonscientific. com) to learn more about Oregon Scientific products such as digital cameras; MP3 players; children's electronic learning products and games; projection clocks; health and fitness gear; weather stations; and digital and conference phones. [. . . ]