User manual OREGON SCIENTIFIC BAR628HG-EASY WEATHER STATION ADVANCED

[. . . ] 5 Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Set Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Activate Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Open the remote sensor battery compartment with a small Phillips screwdriver. Insert the batteries, matching the polarity (+ and -) as shown in the battery compartment. SWITCH OPTION Channel Channel 1-3. If you are using more than one sensor, select a different channel for each sensor. 4 3. Then, press and hold MEM and CHANNEL on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the "Data Transmission" section for more information. ) 5. Secure the sensor in the desired location using the wall mount or table stand. SEARCH FOR SENSOR To search for a sensor, press and hold MEM and CHANNEL (on the main unit) for 2 seconds. NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location. NOTE Signals from household devices such as doorbells, electronic garage doors, and home security systems may cause temporary reception failure. The reception will resume once the interference ends. CLOCK The clock automatically synchronizes the current time and date when it is brought within range of the radio signal DCF77 generated from Frankfurt, Germany for Central Europe (model BAR628HG) or MSF60 generated from Rugby, England (model BAR628HGU). NOTE The signals are collected by the main unit when it is within 1500 km (932 miles) of a signal. For best results: · Insert the batteries and select the channel before you mount the sensor. · Do not place the sensor more than 30 metres (98 feet) from the main (indoor) unit. · Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture. · Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects. · Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission. You may need to experiment with various locations to get the best results. Initial reception takes 2-10 minutes, and is initiated when you first setup the unit, and whenever you press RESET. [. . . ] The Calendar must be set for this feature to work, see "Set Clock" section. · Press or to view the moon phase for the next or previous day. · Press and hold or to scan quickly through the years (2001 to 2099). WEATHER FORECAST This product forecasts the next 12 to 24 hours of weather within a 30-50 km (19-31 mile) radius with 70 to 75 percent accuracy. Manually activate clock feature (5) Temp Remote sensor Shows "LLL" or "HHH" Cannot locate remote sensor Cannot change channel Data does not match main unit Temperature is out-of-range Check batteries(5) Check location (5) Check sensors. [. . . ]