User manual OREGON SCIENTIFIC BAR122HGLA

[. . . ] BATTERY COMPARTMENT Accommodates four UM-3 or "AA" size alkaline batteries C2. RESET SLOT Resets the unit by returning all setting to their default values C3. REMOVABLE TABLE STAND For mounting the remote sensor on a flat horizontal surface. RECESSED WALL-MOUNT HOLE For mounting to a wall or vertical surface CONTROL BUTTONS B1. [. . . ] Insert the batteries strictly according to the polarities shown inside the battery compartment. Protect the environment by taking exhausted batteries to authorized disposal stations. 3. Replace the battery compartment door. Note: For both the remote sensor and the main unit, replace batteries when they are low. The low battery indicator [ ] in the indoor or / and outdoor temperature window will be displayed when the batteries are low. HOW TO READ THE KINETIC WAVE DISPLAY The kinetic wave display shows the signal receiving status of the main unit. No signal received in search mode. 4 MAXIMUM AND MINIMUM TEMPERATURES The maximum and minimum recorded temperatures will be automatically stored in memory. Press MEM again to alternate between the maximum, minimum, and current temperatures. Subsequently, if you press MEM after the memory has been erased, the maximum and minimum temperature will have the same values as the current reading. TRANSMISSION COLLISION Signals from other household devices, such as door bells, home security systems and entry controls, may interfere with those of this product and cause temporarily reception failure. This is normal and does not affect the general performance of the product. The transmission and reception of temperature readings will resume once the interference recedes. NOTE ON °C AND °F The unit of temperature display is selected on the °C/°F slide switch. Note: The remote temperature display on the main unit is dominated by the selection on the °C/°F slide switch of the main unit. Whatever the display units of the remote sensors, they will be automatically converted to the choice of the main unit. DISCONNECTED SIGNALS If without obvious reasons the display for a particular channel goes blank, press CHANNEL and MEM simultaneously to enforce an immediate search. The minute digits will blink. - No signal Repeat the same procedure to set the minutes, current date, month, display language, day-of-week and offset for the alternate time zone. For the language display, you can choose among English (E), German (D), French (F) and Italian (I). For the alternate time zone, which is indicated by the ZONE icon, enter the hour offset using the and buttons and the BAR113 will calculate the second time accordingly. If there is an item you do not wish to change, simply press MODE/ SET to bypass the item. The display will return to the mode last chosen. - Receiving If you wish to disable the auto-reception feature, press the button for three seconds. To enable the feature again, press the button for three seconds. The radio reception signal [ ] will start blinking to initiate reception automatically. HOW TO SET AND ARM THE ALARMS The BAR113 has two alarms, ALARM 1 and ALARM 2. They can be invoked together or independently. 7 GB GB To set an alarm: 1. Press [ ] once to select ALARM 1 or again to select ALARM 2 the last selected time of the alarm will be displayed. If you have never set the alarm before, the time will be displayed as 12:00am. 3. Enter the hour using 4. Press [ and . NOTE ON OUTDOOR-REMOTE TEMPERATURE Once batteries are in place in the remote unit, it will start transmitting samplings at 30-second intervals. If no signals are received when the outdoor-remote temperature is " will be displayed. To force the main unit to selected, " search for remote sensor signals, press MEM and CHANNEL buttons simultaneously. [. . . ] Pressing [ ] or [AL ON/OFF] will stop the alarm, which is still armed and will activate at the set time the following day. If [AL ON/OFF] button is pressed again, the alarm will be stopped and deactivated all together. 8 THE RESET BUTTON The button is only used when the unit is operating in an unfavorable way or malfunctioning. All settings will return to their default values. HOW TO WALL-MOUNT OR USE THE TABLE STAND The unit can be wall-mounted using its recessed screw holes or place on a flat surface by attaching the table stand. [. . . ]