User manual OREGON SCIENTIFIC BAR113-NIC-E

[. . . ] [MEM] BUTTON Displays minimum and maximum temperature readings, and erases memory data ] BUTTON B3. MODE/SET BUTTON Changes the display mode of the clock, and alters time/date setting B5. UP [ ] DOWN [ ] BUTTONS Sets the increase or decrease in the value of a setting. [. . . ] Note: The remote temperature display on the main unit is dominated by the selection on the °C/°F slide switch of the main unit. Whatever the display units of the remote sensors, they will be automatically converted to the choice of the main unit. DISCONNECTED SIGNALS If without obvious reasons the display for a particular channel goes blank, press CHANNEL and MEM simultaneously to enforce an immediate search. Note: When the temperature falls below freezing point, the batteries of outdoor units will freeze lowering their voltage supply and the effective range. The transmission is within range and the path is clear of obstacles and interference. 5 WEATHER FORECAST FUNCTION The unit is capable of detecting atmospheric pressure changes. Based on collected data, it can predict the weather for the forthcoming 12 to 24 hours. The effective range covers an area of 30 to 50 km. Indicator displays on the unit Forecast Sunny Slightly Cloudy Cloudy Rainy GB GB NOTE: 1. The accuracy of a general pressure-based weather forecast is about 70% to 75%. The weather forecasts from this unit are predictions that cover the next 12 to 24 hours. The "Sunny" icon, as applies to nighttime, implies clear weather. MODE 4. Hour-Minute-Day of the Week Day-Month Each press on the MODE button will toggle the display in the above order. Note: The bottom line of the display will be replaced by the alarm ] button is pressed. time if the ALARM [ CALENDAR CLOCK DISPLAY MODES The BAR113 supports four time display modes in the sequence of: MODE 1. Hour-Minute-Second (of local time) Day-Month (of local time) ABOUT RADIO RECEPTION The BAR113 is designed to automatically synchronize its calendar clock once it is brought within range of the UK Rugby MSF-60 radio signal. When the BAR113 is within range, its radio-control mechanism will override all manual settings. When the unit is receiving radio signal, the RADIO RECEPTION signal will start to blink. A complete reception generally takes about two to 10 minutes, depending on the strength of the radio signal. When the reception is complete, the RADIO RECEPTION signal will stop blinking. [. . . ] Without interruption, the alarm will go off for a total of two minutes. If a second alarm goes off when the first alarm is sounding off, the first alarm will be disabled automatically. NOTE ON SETTING REMOTE SENSOR CHANNELS The unit has an auto-scan function that sequentially displays temperature readings of up to three remote sensors. In order to function properly, each remote sensor must be set to different channels. HOW TO STOP AN ALARM To stop an alarm, you can use either press [ ] button or [AL ON/ OFF] button. [. . . ]