User manual ONEFORALL URC 8350

[. . . ] Replay key Press Replay to command your PVR to instantly replay the last 7 seconds of a program you are watching. Energy Saver Key This key will allow you to switch to energy saving mode. Guide In TV and/or STB mode you will obtain the "Guide" function, if available on your original remote. MENU Key The MENU key controls the same function as it did on your original remote. [. . . ] You may have to press this key many times (up to 150 times) so please be patient. If you skip past a code, you can go to the previous code(s) by pressing the DOWN key. Remember to keep pointing the URC-8350 at your Television while pressing this key. (*) to scan through other device types: Press: to scan through codes for: Television / LCD / Plasma DVD player/recorder or PVR CD, Amplifier or Amp. /Tuner or Miscellaneous Set-Top-Box or Satellite Receiver or Cable Converter Most TV's do not switch on pressing the POWER key. Please try pressing a "number" key or the "TV-text off" key to switch your TV back on. If you cannot control your Television properly, please continue the Search Method, you may be using the wrong Code. To search for the code for another device follow the instructions above only press the appropriate device key instead of TV during step 2 and the appropriate number during step 5. (How to copy functions from your original working remote onto the ONE FOR ALL URC 8350) The URC-8350 comes with a complete library of pre-programmed codes. After you have set up the URC-8350 for your device, you may find that there are one or more keys that you had on your original remote, which do not have a place on the URC-8350 keypad. As a convenience, the URC-8350 offers a special Learning feature that allows you to copy any function from your original remote control onto the keypad of the URC-8350. Before you start: Make sure your original remote control is working correctly. Make sure neither your URC-8350, nor your original remote control is pointing at your device. Example: To copy the "mono/stereo" function from your original TV remote onto the "LAST" key of your URC-8350. Place both remote controls (the URC-8350 and your original) on a flat surface. Make sure the ends which you normally point at your device are facing each other. Press and hold down REWIND + FASTFORWARD simultaneously until the URC-8350's LED (red light) blinks twice (the LED will blink once and then twice). Press the device key (on the URC-8350 remote) to select the mode to which you want to copy the learned function (example: TV key). Press the key (on the URC-8350 remote) where you want to place the learned function (example: LAST key). Press and hold the key (on your original remote) that you want to copy until the LED on the URC-8350 blinks twice (example: "mono/stereo" key). If you want to copy other functions within the same mode, simply repeat steps 5 and 6 pressing the next key you want to copy by learning. If you want to copy other functions to a different mode, then repeat from step 4 onwards and press the applicable mode key. [. . . ] Simply assign these keys to the Power Plugs HC-8000) as you would do a number. If you experience interference, it is possible to change the code of the Energy Saver Mode on your remote to avoid this. the default code is 41000 , but it is possible to change the code to 41001 , 41002 etc up to 41015. To change the code, set the Light Mode up as you would do a normal device (see page 5), using codes 41000 - 41015. [. . . ]