User manual ONEFORALL URC 7721

[. . . ] - In order to avoid having to re-program your ONE FOR ALL 2 after you remove the batteries, you will need to insert new batteries within 5 minutes. - On the inside of the battery compartment door you will find a label on which to write your Set-Up Codes for future reference. This you will do after setting up your ONE FOR ALL 2 remote for your devices. Magic Key: The Magic key is used to set-up your ONE FOR ALL 2 Remote Control and to access special functions. [. . . ] If on your original remote control these keys are used for Menu navigation, the ONE FOR ALL Fastext keys may operate in the same way. - For a more detailed explanation of the Teletext and Fastext functions, please refer to the manual of your television. Remember, different televisions control Teletext and Fastext in different ways. Not all Teletext functions may be available for your particular model. Make sure your device (television) you wish to operate is switched on (not in standby). Press the device mode key (TV) on the ONE FOR ALL 2 remote for the device you wish to set up. Press and hold down MAGIC until the red light blinks twice (the red light will blink once then twice). Now aim the ONE FOR ALL 2 remote at your device (television) and press POWER. If your device switched off, the ONE FOR ALL 2 is ready to operate your device. - Most TV's do not switch back on pressing the POWER key, please try pressing a "number" key or the "TV-text off" key to switch your TV back on. - If your device does not respond, follow steps 1 through 6 with each code listed for your brand. If none of the codes listed for your brand operate your device, then try the Search Method described on page 7, even if your brand is not listed at all. If your device does not respond or is not functioning properly with one of the codes, try another code listed under your brand. - If the original remote control from your DVD Player/DVD-R did not have a POWER key, press PLAY instead of POWER during step 6. - To set up your other devices, follow the same instructions above, only press the appropriate device key during step 3. - Remember to press the correct device key before operating your device. - Write your device code in the applicable four digit boxes provided in the battery compartment and on page 8 for future reference. Devices can be found under the following keys: --> If your device does not respond to the ONE FOR ALL 2 after you have tried all the codes listed for your brand. The Search Method allows you to scan through all the codes contained in the memory of the ONE FOR ALL 2. Example: To search for your television code: Press and hold down MAGIC until the ONE FOR ALL 2 red light blinks twice (the red light will blink once then twice). Now press CH+ over and over, until your Television turns off (every time you press the CH+ key the ONE FOR ALL 2 will send out a POWER signal from the next code contained in the memory). You may have to press this key many times (up to 150 times) so please be patient. [. . . ] Try repeating the Direct Set-Up using another code listed under your brand or start the search method over again to locate the proper code. Enter the program number exactly as you would on your original remote. As a safety feature on your ONE FOR ALL 2, you must press the Record key twice. Make sure you are using new batteries and are aiming the ONE FOR ALL 2 at your device. [. . . ]