User manual ONEFORALL URC 7711

[. . . ] - On the inside of the battery compartment door you will find a label on which to write your Set-Up Codes for future reference. This you will do after setting up your ONE FOR ALL 1 remote for your devices. Magic Key: The Magic key is used to set-up your ONE FOR ALL 1 Remote Control and to access special functions. Power Key: The Power key controls the same function as it did on your original remote. [. . . ] - For a more detailed explanation of the Teletext and Fastext functions, please refer to the manual of your television. Remember, different televisions control Teletext and Fastext in different ways. Not all Teletext functions may be available for your particular model. Make sure your device (television) you wish to operate is switched on (not in standby). Press and hold down MAGIC until the red light blinks twice (the red light will blink once then twice). Now aim the ONE FOR ALL 1 remote at your device (television) and press POWER. If your device switched off, the ONE FOR ALL 1 is ready to operate your device. - Most TV's do not switch back on pressing the POWER key, please try pressing a "number" key or the "TV-text off" key to switch your TV back on. - If your device does not respond, follow steps 1 through 5 with each code listed for your brand. If none of the codes listed for your brand operate your device, then try the Search Method described on page 7, even if your brand is not listed at all. If your device does not respond or is not functioning properly with one of the codes, try another code listed under your brand. - Write your device code in the applicable four digit boxes provided in the battery compartment and on page 8 for future reference. --> If your device does not respond to the ONE FOR ALL 1 after you have tried all the codes listed for your brand. The Search Method allows you to scan through all the codes contained in the memory of the ONE FOR ALL 1. To search for your television code: Press and hold down MAGIC until the ONE FOR ALL 1 red light blinks twice (the red light will blink once then twice). Now press CH+ over and over, until your Television turns off (every time you press the CH+ key the ONE FOR ALL 1 will send out a POWER signal from the next code contained in the memory). You may have to press this key many times (up to 150 times) so please be patient. If you skip past a code, you can go to the previous code(s) by pressing the CH- key. Remember to keep pointing the ONE FOR ALL 1 at your Television while pressing this key. Please try pressing a "number" key or the "TV-text off" key to switch your TV back on. - If you cannot control your Television properly, please continue the Search Method, you may be using the wrong Code. (To find out which code is currently programmed) Once you have Set-Up your ONE FOR ALL 1, you can blink back your Set-up Code for future reference. [. . . ] You may care to visit our Internet-site: Our internet-site has many advantages: - 24 hours access - no waiting time - page for Frequently Asked Questions - info about the ONE FOR ALL product range Before contacting us, by Fax, E-mail or Phone, make sure you have the required information available by filling in the table below. What do we need to know before you contact us: 1 2 3 Device TV That you have the ONE FOR ALL 1 URC-7711 universal remote. Type/model numbers can often be found in your equipment owner's manual or on the factory plate behind the device. /ONE FOR ALL warrants to the original purchaser that this product will be free from defects in materials and workmanship under normal and correct use for a period of one (1) year from the date of original purchase. [. . . ]