User manual ONEFORALL URC 3720

[. . . ] If your device switches off, the ONE FOR ALL 2 is ready to operate your device. Next, switch your device back on (pressing ON, a number key or CH+) and try all the remote's functions to ensure they are working properly. If the functions do not work properly, repeat steps 1-5 using another code listed under your brand. If your device does not respond, follow steps 1 to 5 with each code listed for your brand. [. . . ] Now enter the Set-Up code for your second TV by pressing: (*) (TV code) (**) (**) Example: To reset the SAT key to its original mode, press: (*) (**) Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. This feature allows you control the volume from a certain device, without having to change to that device mode (e. Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. Result: within every mode, whenever you press the VOL+/- or MUTE keys, this will be send out from TV mode. Press and hold down the MAGIC key until the red LED underneath the SAT key will blink twice. Result: being in SAT mode, you will be able to control VOL+/- or MUTE functions of your PVR (provided it has volume control). To cancel the , , Volume Lock" for all modes: 1 Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. Macros (Direct) You can program your ONE FOR ALL 2 to issue a sequence of commands at the press of one button. Any sequence of commands you regularly use can be reduced to one key stroke for your convenience. Example: To switch off your Television and Satellite Receiver with one keypress (e. Red key): 1 Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. To store the Macro, press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. Whenever you press the "Red" key, the ONE FOR ALL 2 will switch off your Television and Satellite Receiver. Make sure that you program a Macro on a spare key that you don't use in any mode. Once you program a Macro on a specific key, the sequence will work regardless of the mode (TV and SAT) you are using. If you had to hold down a key for a few seconds on the original remote control to get a function, this function may not work in a macro on your ONE FOR ALL remote. To avoid accidental recordings with the ONE FOR ALL 2, you must press the Record key twice to begin recording. Because of this, we recommend you not to assign a Macro or Shifted Macro to the Record key. If you program a Macro on a key, the original function will become shifted (excluding REW, PLAY, PAUZE, FF, SKIP Forward, SKIP Back, STOP, REC, Red, Green, Yellow and Blue). To erase the Macro from the Red key, press: 1 Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. Shifted Macros If you do not want to sacrifice any key it is also possible to install a "Shifted Macro". [. . . ] 1 Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. Result: now also being in TV mode you will be able to play your SAT (PVR). To restore the play key in the TV mode to it's original function press: TV MAGIC** 994 PLAY PLAY (**) (**) Press and hold down the MAGIC key until the red LED underneath the last selected device key will blink twice. Try repeating the Direct Set-Up using another code listed under your brand or start the search method over again to locate the proper code. [. . . ]