User manual OMRON R5

[. . . ] â· Do not insert batteries with their polarities in the wrong direction. Do not press the START/STOP button when the cuff is not wrapped on the wrist. Do not store the monitor under direct sunshine, where there is high temperature and humidity, dust, contact with corrosive gases or water. Do not use benzine, thinner, gasoline, or alcohol to clean the monitor. [. . . ] Measurement is over and blood pressure values and pulse are displayed. when the measurement is over , a mark flashes , and the cuff deflates automatically. Then a mark turns on and blood pressure and pulse rate are displayed simultaneously. * If a measurement cannot be made or the blood pressure values are displayed abnormally high (low), refer to Page 15. * If the Velcro tape comes off during the measurement, wrap the wrist cuff snugly as shown in Page 7 and measure again after fastening the Velcro tape. * Even if you forget to turn off the power, the monitor will turn off automatically in approximately 2 minutes. The measurement values can be recalled after completion of the measurement or even when the power is off. Each time the "M" button is pressed, the previous measurement values are displayed. When all the stored measurement results are displayed, the display of the present measurement result or the first measurement result will resume (if the memory is recalled when the power is off. ) * Immediately after completion of the measurement, the memory may not be called even by pressing the "M" button. In that case, leave the finger from the "M" button and press it again to call the memory. After reading the blood pressure values and pulse rate stored in the monitor, press the START/STOP button to turn off the power. * Even if you forget to turn off the power, the monitor will turn off automatically in approximately 2 minutes. * The stored measurements will remain in the memory even when the batteries are removed for battery replacement. ) (1) Press the "M" button while the power is off to call the measured data. (2) Press the START/STOP button for more than 2 seconds while pressing the "M" button. * If you press the "M" button first, the power will turn off. (4) When the "M" mark stops blinking, the contents of the memory are deleted and the display of no memory appears. How to clean the monitor Wipe the monitor with a cloth, moistened with water or detergent, then wipe it dry with a dry cloth. Even if the cloth lining inside the wrist cuff becomes fluffy, it does not affect the measuring accuracy. Keep the main unit in the storage case when carrying or storing the monitor. If you are not going to use the monitor for a long period of time such as for more than three months, remove the batteries from the monitor to prevent leakage. [. . . ] It is important to observe the correct measuring method in order to measure blood pressure accurately. (1) Take a correct posture so that the wrist cuff is at the same level as the heart. Learn your blood pressure trend In order to know the fluctuation trends of your blood pressure, it is important to measure your blood pressure at the same time every day at home and recording it. Furthermore, do not worry about your blood pressure each time you measure. [. . . ]