User manual OLIVETTI OFX 120

[. . . ] Disclaims any liability of any kind for any damages whatsoever resulting from the use of the software and of the manual. The same thing can be said for any person or company involved in the creation, realization, production and verification of the software and of the manual. The registered trademarks are the property of their respective owners. NOTE: describes problems that could occur when using the whiteboard and how to avoid and resolve them. [. . . ] When the installation completed message is displayed, click on "Finish" then, on returning to the main screen, click "Exit". This type of installation is recommended only when upgrading the software provided with the whiteboard. Choose the language you want to install and confirm with "Next". Connect the cable to a USB port on the computer (the other end of the cable must be connected to the Interactive Whiteboard). Normally it is not necessary to execute this procedure if the "Express installation" has already been performed. You can check if the USB cable driver has been installed by clicking with the mouse right button on "Computer Resources", then with the mouse left button on "Properties" "Hardware" "Device Manager" "Port" (COM and LPT)". Alternatively, insert the software disk, click on the Oliboard program logo and run the software removal guide following the instructions on the screen. To run the software, first of all the software driver of the whiteboard must be started, the orientation operation performed if necessary, after which the whiteboard software can be started. NOTE: If the message "Communication with whiteboard failed", first make sure that the cable of the whiteboard is connected correctly between the computer and the whiteboard. click on the Oliboard Driver icon and select "Reconnect" in the popup menu. If this warning persists, make sure that the driver of the USB cable is installed correctly (see the note on how to check installation of the USB cable on page 13). If a problem occurs, enter the command using this other sequence: su ­ root password. Enter the commands necessary for accessing the folder where Oliboard_for_Linux_V2. Before removing the software, deactivate the software driver (via the "Exit" command that can be activated by clicking on the driver icon in the control bar) and exit from the application if it is still running. The Oliboard for Linux software can be removed from your computer in one of two ways. The first way is to follow the on-screen instructions, the second way is to use the command line. To run the software, you must first of all run the whiteboard software driver, then perform the orientation operation if necessary before finally starting the whiteboard software. When the Oliboard Driver starts, the related icon appears on the panel in the top right corner of the desktop: When the driver starts, the whiteboard runs a connection check. If an error is encountered, make sure that the whiteboard cable is connected correctly between the computer and the whiteboard. At this point, you must install the software driver for the USB cable. Go back to the main installation display mask and click on "USB_Cable_Driver"and then to FTDI driver to enter in the folder containing two installation drivers: - FTDIUSBSerialDriver_10_3. Click on "Continue" and follow the instructions displayed until installation completes. [. . . ] In order to execute the registration process, it is necessary a direct connection to Internet and to insert the activation code (normally included in the CD-ROM). ", check whether there is a good connection between whiteboard and the computer. Make sure that the special-purpose connection cable of the whiteboard has been used, and that the cable has been connected correctly. If this message appears when the computer should not be connected to the whiteboard, make sure that the "autostart" parameter of the Oliboard driver has been deactivated (click on the icon to deactivate the parameter). [. . . ]