User manual OLIVETTI D-COPIA 20

[. . . ] Direzione Home/Office Via Jervis, 77 - 10015 Ivrea (ITALY) www. olivettilexikon. com Copyright © 2001, Olivetti All rights reserved March 2001 The manufacturer reserves the right to carry out modifications to the product described in this manual at any time and without any notice. ENERGY STAR is a U. S. registered mark. The ENERGY STAR program is an energy reduction plan introduced by the United States Environmental Protection Agency in response to environmental issues and for the purpose of advancing the development and utilization of more energy efficient office equipment. This machine has been approved, under the terms of Council Decision 98/482/EC, for Europe-wide connection as a single terminal to an analogue Public Switched Telephone System (PSTN) system. However, due to differences between individual PSTNs in the various countries, the approval does not unconditionally guarantee success operation of every PSTN termination point. If you encounter any problems, you should contact your supplier immediately. This product's conformity with quality requirements is certified by the Mark it bears, in accordance with the 1999/05/EC standard. Network compatibility declaration This product has been designed and developed to operate in the networks of all European Community countries, and in those of Switzerland and Norway. [. . . ] The width can be selected from 6, 12 and 18 mm. 6 Press the enter key. The message display will return to the "READY TO COPY. " screen. 5-6 CHAPTER 5 FUNCTIONS 5. One copy from two or four originals [Layout copy] 2 or 4 originals can be combined into a single copy. The borderline of each original can also be marked with a solid line or dotted line. (2) 4-UP Use this mode to copy four originals onto one sheet. It can be used in conjunction with the duplex copy mode to copy eight originals onto one sheet, though this will require the optional duplex unit. (When setting originals on the platen, originals are arranged in the order from 1, 2, 3 and 4. ) NOTE · The original and copy paper must be the standard size. (1) 2-UP Use this mode to copy two originals onto one sheet. It can be used in conjunction with the duplex copy mode to copy four originals onto one sheet, though this will require the optional duplex unit. (When setting the originals on the platen, originals are arranged in the order from 1 to 2. ) NOTE · In the "4-UP" mode, the available modes differ depending on the orientation of the originals. · When performing duplex copy, the images on the back side can be rotated. NOTE · When performing duplex copy, the images on the back side can be rotated. 5-7 CHAPTER 5 FUNCTIONS 1 Press the Layout key to light the indicator. The layout copy setting screen will appear. 7 Press the Start key. If originals are set in the DF, all originals are scanned one by one and copying performed accordingly. If setting originals on the platen, go to the next step. 2 Press the cursor down or up key to select the layout copy mode. In the "4-UP" mode, when setting originals horizontally, select "4-UP (Z)"; when setting originals vertically, select "4-UP (N)". 8 Replace the original and press the Start key. Carry out the same procedures to the originals of which copying will be performed, and finally, press the enter key. Copying will start. 3 4 Press the enter key. Press the cursor down or up key to select the type of the borderline. Select from "DOTTED" or "SOLID". 5 6 Press the enter key. The message display will return to the "READY TO COPY. " screen. Set the original(s). IMPORTANT · Before setting original on the platen, make sure they are in a sequence that produces images in the numbered positions. · Select the paper according to the situation. 5-8 CHAPTER 5 FUNCTIONS 6. Sorting automatically [Sort copy] Since copying is performed after memorizing multiple originals, copies can be sorted into the required number of sets even without an optional finisher. 3 Enter the number of copies and press the Start key. When setting the originals on the platen, go to the next step. NOTE · If "ON" is set in "$ ROTATE SORT" on page 6-13, and the paper size is A4, the orientation of each set of copies is changed, thus making copies easy to handle. To use this setting, A4 paper must be set lengthwise in one drawer and widthwise in the other. 4 Set the next original and press the Start key. NOTE · Repeat this operation for all originals. 5 1 2 Set the original(s). After all the originals have been scanned, press the enter key. [. . . ] 46. 4 kg < 70 dB (A) 891 mm (W) x 603 mm (D) ADF (automatic document feeder), RADF (reversing auto document feeder), drawer, finisher, duplex unit, job separator, key counter, printer board, network board, network scanner, original holder Copying speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Warm-up time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . First copy time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Zoom ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Image storage memory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]