User manual OLIVETTI COPIA 9915F

[. . . ] WARNING: Provided with some models only ACHTUNG: Wird nur mit einigen Modellen geliefert BEMÆRK: Leveres kun sammen med enkelte modeller 1 2 3 4 5 6 7 Original cover Side cover Manual bypass Paper guides Side cover open button Front cover Paper tray (two paper trays may be available depending on the model) 8 Operation panel 9 Original table 10 Cover for optional printer interface 11 12 13 14 15 16 17 18 19 20 Paper output tray Paper output tray extension Handle Power switch Power cord socket TD cartridge lock release button TD cartridge Drum cartridge Drum cartridge handle Transfer charger 21 22 23 24 25 26 27 28 29 30 Charger cleaner Fusing unit release tab Paper feed roller SPF and R-SPF exit area Middle tray Original guides Document feeder tray Feeding roller cover Bypass tray Bypass tray guides 1-12) 2 Light ({) and dark (}) keys and exposure indicators Use to adjust the MANUAL (=) or PHOTO ( ) exposure level. Q Paper feed location indicator Light up to show the selected paper feed station. W Zoom keys (N, L) Use to select any reduction or enlargement copy ratio from 50 to 200% in 1% increments. Press to clear the display, or press during a copy run to terminate copying. [. . . ] The original image must be smaller than the paper or media for copying. If the original image is bigger than the paper or media, this may cause smudging on the edges of the copies. Insert a single sheet of copy paper (print face down) into the feed slot of the manual bypass. To close the bypass tray, perform step1 and then step 2 in the illustration and push the round projections at the right of the tray until they click. Insert the copy paper (print face down) all the way into the bypass tray. Transparency film, labels, and other special purpose papers must be fed individually. After loading copy paper, to cancel the blinking "P" without restarting copying, press the clear (C) key. The "P" in the display will go out and the ready ( ) indicator will light up. Example: The following two originals will be copied onto two sides of copy paper. Place the first original face down on the original table with the TOP toward the LEFT. The first copy can be made using either the paper tray or the manual bypass. 5 Auto power 0¶OFF shut-off mode * 1¶ON Factory default settings are indicated with an asterisk (*). Select the desired parameter using the right copy quantity (<) key. To change the setting or to set another mode, press the clear (>) key. Press the light ({) or dark (}) key to return to the normal copy mode. The TD cartridge replacement required (s) indicator will light up when toner is needed. for more information on purchasing the TD cartridge , see SUPPLY PART NUMBERS AND STORAGE on page 1-37. If copying is continued while the indicator is lit, copies will gradually become lighter until the copier stops and the indicator begins blinking. After the copier stops, it may be possible to make a few more copies by taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge. During a long copy run of a dark original, the ready ( ) indicator may blink, the s indicator light up, and the copier stop, even though toner is left. The copier automatically replenish the toner level for up to 2 minutes and then the ready ( ) indicator will light up. [. . . ] 1 [B (A)] models with SPF Sound Pressure Level LPA (bystander positions) Copying: 40 [dB (A)], Standby: Background noise level Noise emission measurement in accordance with ISO 7779. First-copy time may differ depending on operating conditions, such as power-supply voltage and room temperature. As a part of our policy of continuous improvement, the manufacturer reserves the right to make design and specification changes for product improvement without prior notice. the performance specification figures indicated are nominal values of production units. [. . . ]