User manual OLIVETTI COPIA 9910

[. . . ] In some areas, the "POWER" switch positions are marked "I" and "0" on the copier instead of "ON" and "OFF". CAUTION: For a complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. These can be re-used for transporting the machine, should it be necessary. [. . . ] The first copy can be made using either the paper tray or the manual bypass. Replace the first original with the second original face down on the original table with the TOP toward the RIGHT and close the original cover. Make sure that the first and second originals are oriented in the same way on the original table. Both the first and second originals can be set in the SPF but they must be set separately. If the stream feeding mode for the SPF has been enabled, set the second original after the SPF ( ) indicator goes out. For tablet binding, turn the first copy over left to right as shown below. For booklet binding, turn the first copy over top to bottom (not shown). Power save modes (page 1-20) The copier has two power save modes of operation: preheat mode and auto power shut-off mode. Preheat mode When the copier enters the preheat mode, the power save (i) indicator will light up and other indicators will remain on or off as before. In this condition, the fuser in the copier is maintained at a lower heat level, thereby saving power. To copy from the preheat mode, make desired copier selections and press the print ( ) key using the normal copying procedure. Auto power shut-off mode When the copier enters the auto power shut-off mode, the power save (i) indicator will light up and other indicators will go out. The auto power shut-off mode saves more power than the preheat mode but requires a longer time before starting copying. Then make desired copier selections and press the print ( ) key using the normal copying procedure. Auto clear (page 1-20) The copier returns to the initial settings a preset amount of time after the last copy is made. The exposure indicator marked "1" will light up, indicating the toner save mode is selected. To return to the standard mode, repeat the procedure but use the dark (}) key to select exposure level "5" in step 3. Press and hold down the exposure mode selector key for approximately 5 seconds. The user programs allow the parameters of certain functions to be set, changed, or cancelled as desired. Setting the power save modes and auto clear time, and stream feeding mode. Press and hold down the light ({) and dark ( }) keys simultaneously for more than 5 seconds until all the alarm indicators (w, t, s) blink and "­ ­ " appears in the display. Use the left copy quantity (<) key to select a user program number. [. . . ] When ordering supplies and option, please use the correct part numbers as listed below. Clean and dry, · Store copy paper in the wrapper and lying flat. Paper stored out of the wrapper or in packages standing on end may curl or get damp, resulting in paper misfeeds. When moving this copier, be sure to remove the TD cartridge in advance. [. . . ]