User manual OKI C5300NCCS REFERENCE GUIDE

[. . . ] Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. Oki assumes no responsibility for the results of errors beyond its control. Oki also cannot guarantee that changes in software and equipment made by other manufacturers and referred to in this guide will not affect the applicability of the information in it. Mention of software products manufactured by other companies does not necessarily constitute endorsement by Oki. [. . . ] Microsoft provides on-line help with all of their operating systems and this is a good reference point for the exact details of each configuration option within Windows. The network printer supports the following protocols that can be used in conjunction with the Windows operating system: > > > TCP/IP IPX (Novell NetWare) NetBEUI There are a number of options available when printing using TCP/IP for Windows. Into Windows and are displayed as options when using the Add Printer Wizard. Although there are some differences in configuration options between the various Windows platforms, the procedure for printing using TCP/IP is the same. This can be confirmed by checking the network settings from within the Control Panel. If TCP/IP has not been installed refer to the section below Installation of TCP/IP protocol. If not already configured, a suitable IP address, Subnet Mask and Gateway address should be configured. If your network environment uses domain names, DNS should be enabled and configured on your system. In the [Select Network Component Type] dialogue box, select [Protocol] then click [Add]. In the [Select Network Protocol] dialogue box, select [Microsoft] from the list of manufacturers, then select [TCP/IP] from the list of network protocols, then click [OK]. In the [Select Network Component Type] dialogue box, select [Protocol] then click [Add]. In the [Select Network Protocol] dialogue box, select [Internet Protocol (TCP/IP)] then click [OK]. Once the protocol has been installed and configured in Windows, the next step is to configure the TCP/IP parameters in the network printer. Select the appropriate network card, using the Ethernet address to identify it, and click [Next]. The Ethernet address (MAC Address) of the printer can be found on the self-diagnostic printout, which can be printed by pressing the push-button on the network card for two seconds and then releasing it. When using lpr in UNIX and other TCP/IP environments, please select [Yes]. To use in a TCP/IP environment, an IP address should be assigned to the Ethernet board. If [Yes] has been selected and TCP/IP is the only working protocol and the IP address has not already been assigned, you can either obtain an IP address automatically or assign an IP address. When [Obtain an IP address automatically] is selected, the device IP address will be automatically assigned by the DHCP server. In an environment without a DHCP server, please assign the IP address manually. If you are assigning an IP address, you need to enter: >An IP address >Submit mask >Gateway address. Consult your network manager to ensure that the NetWare file server is properly installed and working on the network. [. . . ] However, if the user name is [root], the password set under TELNET or the utility are required. Move to the logical directory; it is not possible to output print data to the root directory. There are two types of transfer mode: BINARY mode, in which the file contents are output as it is and ASCII mode, which converts the LF code to the CR+LF code. Logout from the network card using the quit command Ftp> quit Three states can be verified using the quote command stat: the IP address, login user name and transfer mode. [. . . ]