User manual OKI B930N SETUP GUIDE

[. . . ] Width (2): - with High Capacity Feeder (HCF) = 47 inches (118 cm) - with finisher = 60 inches (153 cm) - with HCF and finisher = 86 inches (218 cm) · Height (3): - with optional tray = 35 inches (89 cm) - with finisher = 47 inches (119 cm) Place the printer and any optional components at your selected location. Align the holes on the bottom of the printer with the positioning guides on the tray, and place the printer on the tray. [. . . ] Insert the two hooks on the bottom of the duplex unit into the printer's receptors (1). Close the duplex unit cover Remove the access cover from the back of the printer (1), connect the duplex unit interface Lift the duplex Unit until the upper hooks are latched in the printer. Guide needs to be moved from the body of the printer up to the exit module. If the duplexer is installed, the guides from the printer itself must be moved to the duplexer exit module. The guides are two pieces of rubber and plastic that assist in stacking to the top of the printer. When installing the horizontal transport this Connect finisher power cord to the printer accessory power connection. Slide the drawer out and remove the packing material, then close the drawer. Remove the backing from the Velcro® strip on the back of the Handy Reference Guide and mount it on the side of the printer. Turn the Printer ON and wait for the print server status light to stop blinking. Keep these sheets handy: they contain information you need to set up the printer on your network. [. . . ] Click the utilities and downloads you want to install and follow the instructions. Note: If your printer has a Duplex Unit, Trays or other accessories installed, they must be activated in the printer driver. [. . . ]