User manual ODYSSEY LDK DIGITAL PHONE

[. . . ] This telephone should not be placed in a built-in installation unless proper ventilation is provided. Operate this telephone using the electrical voltage as stated on the base unit or the owner's manual. If you are not sure of the voltage in your home, consult your dealer or local power company. Do not overload wall outlets or extension cords as this can increase the risk of fire or electrical shock. [. . . ] Push the mounting bracket in and down firmly until it snaps into place. Plug the AC adapter into an electric outlet and into the AC jack on the telephone as shown in Figure 5. Once the lower nail head has been inserted, insert the UPPER nail head into the phone's bracket and slide the phone down until it is firmly in place on the wall. Once firmly in place, attach the short line cord to the phone, the AC adapter to the phone and attach the phone's handset. Locate a desired wall phone jack near an AC outlet and hold phone upright. Plug the short phone line cord into the wall outlet as shown in Figure 8. Incoming Voice Volume You can adjust the volume of incoming calls by simply sliding the VOL control. Press the AMPLIFY button as shown in Figure 9 to turn the incoming voice amplifier on or off. Figure 10 - Volume Slide Control Caution: Repeated incremental exposure to amplification levels greater than 18 dB may be harmful to individuals without hearing disabilities. Therefore, do not remove the warning label attached to the back of the handset. If it is likely that a visually impaired person will use the telephone, securely attach the provided warning printed in Braille to the back of the handset (See Diagram A). To change a stored number, repeat the programming process starting with step 1. Special Features (continued) Note: Please do not program 911 in any memory button. Direct Audio Output The AUDIO OUTPUT socket allows you to connect the LDK DIGITAL PHONE to a hearing aid, neck loop, cochlear implant or other assistive listening devices. Connecting the speech processor: Caution: Before plugging any cord into your speech processor, you must consult your implant manufacturer. Speak into the handset when using the Cochlear Implant Adapter Cord Figure 22 - Audio Output Socket To use this port, plug in a compatible auxiliary cable and connect it to your assistive listening device. Cochlear Implant Adapter Cord A cochlear adapter cord is available from Ameriphone that can be used to directly connect the LDK DIGITAL PHONE to a speech processor. During thunderstorms, avoid using telephones (except cordless models). This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug, RJ11 USOC, is provided with this product. [. . . ] Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the Regulatory Compliance (continued) user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. [. . . ]