User manual NUMARK WS31 QUICK START

[. . . ] After microphone is turned on, the signal indicating light of receiver will come on indicating that the signal from the microphone has been received. Rotate the volume knob on the receiver to the desired volume to use the Microphone. 12. Adjust output volume of the hand free transmitter to obtain good sound without distortion. Please record the serial number of your unit as well as the name of the dealer from whom you purchased the unit. [. . . ] Hook up the microphone cable from the output of the receiver to the microphone input on your mixer or recording device. Turn the switch ON and the power indicating light will come on indicating that power is on. For handheld microphones, turn and open the base section of microphone and load in 9V battery. For the hands free models open the transmitter battery door and install battery(s). For hands free models, plug in microphone into the jack on the top of the transmitter. Turn on the switch of microphone and the indicating light will flash once indicating that the microphone is turned ON. If the battery indication light is on this means the battery needs to be replaced. Specifications: RECEIVERS: CARRIER FREQUENCY: 170 ­ 210 MHz VHF BAND CHANNEL: WS-31 SINGLE CHANNEL NON-DIVERSITY WS-32 DUAL CHANNEL NON-DIVERSITY WS-33 SINGLE CHANNEL DIVERSITY QUIETING SENSITIVITY (S/N=30Db, THD=3%) S/N RATIO AT 1mV INPUT: 60 dB UNBALANCE OUTPUT LEVEL: -44dB (MIC) -14dB (LINE) BALANCE OUTPUT LEVEL (WS-33only): -44dB (MIC) -14dB (LINE) THD(1KHz, 10KHzDEV, 1Mv): 0. 5% FREQUENCY DRIFT: +/- 50KHz POWER REQUIREMENT: DC12V/200mA TRANSMITTERS: HANDHELD TRANSMITTER CARRIER FREQUENCY: 170 ­ 210 MHz MICROPHONE TYPE: DYNAMIC UNI-DIRECTIONAL TYPE FREQUENCY RESPONSE: 100Hz- 12, 000Hz RF OUTPUT POWER: 50 mW (Max. ) SENSITIVITY: 100dB SPL at 7KHz FM DEVIATION CURRENT CONSUMPTION: 30mA BATTERY LIFE: 8 Hrs (average) BATTERY TYPE: 006P DC 9V BELTPACK TRANSMITTER + HEADSET MICROPHONE CARRIER FREQUENCY: 170 ­ 210 MHz MICROPHONE TYPE: CONDENSER OMNI-DIRECTIONAL TYPE FREQUENCY RESPONSE: 100Hz- 12, 000Hz RF OUTPUT POWER: 50 mW (Max. ) SENSITIVITY: 100dB SPL at 7KHz FM DEVIATION CURRENT CONSUMPTION: 30mA BATTERY LIFE: 8 Hrs (average) BATTERY TYPE: 006P DC 9V BELTPACK TRANSMITTER + LAVALIER MICROPHONE CARRIER FREQUENCY: 170 ­ 210 MHz MICROPHONE TYPE: CONDENSER UNI-DIRECTIONAL TYPE FREQUENCY RESPONSE: 100Hz- 12, 000Hz RF OUTPUT POWER: 50 mW (Max. ) SENSITIVITY: 100dB SPL at 7KHz FM DEVIATION CURRENT CONSUMPTION: 30mA BATTERY LIFE: 8 Hrs (average) BATTERY TYPE: 006P DC 9V 4. 5. LIMITED PRODUCT WARRANTY What is covered and for how long?NUMARK INDUSTRIES LCC ("NUMARK") warrants to the original purchaser that NUMARK'S DJ mixers and amplifiers are free from defects in material and workmanship under normal use and service for the period commencing upon the date of purchase from an authorized NUMARK dealer and continuing for the following period of time after that date for (2) Years. The warranty is extended to (3) Years with the completion of the warranty card provided that the warranty card is completed and returned within (30) days from the date of purchase. All other NUMARK products are warranted for (1) Year including but not limited to CD players, CD Mix Stations, turntables, preamplifiers, beatkeepers, equalizers, microphones, headphones, cartridges, and all other accessories. This Limited Warranty is conditioned upon proper use of the product by the purchaser. This Limited Warranty does not cover: (a) defects or damage resulting from accident, misuse, abuse, neglect, unusual physical or electrical stress, modification of any part of the product, or cosmetic damage; (b) equipment that has the serial number removed or made illegible; (c) all plastic surfaces and other externally exposed parts that are scratched or damaged due to normal use; (d) defects or damage from improper testing, operation, maintenance, installation, adjustment, or service of the mixers; (e) crossfaders. During the applicable warranty period, NUMARK will repair or replace, at NUMARK'S sole discretion, without charge to the purchaser, any defective component part of the mixer. To obtain service under this Limited Warranty, purchaser must first contact NUMARK and obtain a return authorization number ("RA#"). Purchaser must then return the mixer to NUMARK in an adequate container for shipping, accompanied by purchaser's sales receipt or comparable proof of sale showing the date of purchase, the serial number of the product, and the seller's name and address. To obtain an RA# and assistance on where to return the mixer, contact NUMARK customer service at 401-295 9000. Upon receipt, NUMARK will repair or replace the defective 6. 7. products. NUMARK may, at NUMARK'S sole discretion, use rebuilt, reconditioned, or new parts or components when repairing any product or replace a product with a rebuilt, reconditioned or new product. Repaired mixers will be warranted for a period equal to the remainder of the original Limited Warranty on the original mixer or for (90) days, whichever is longer. All replaced parts, components, boards and equipment become the property of NUMARK. [. . . ] A copy of the original sales receipt must also be included for the equipment to be repaired under warranty. One additional outer layer of packaging must be included to ensure product safety. Failures to do so may inadequately protect the equipment in transit and, therefore, jeopardize the customer's warranty. Numark will not accept COD shipments and no call tags will be issued for merchandise return. [. . . ]